TDF8599 데이터 시트보기 (PDF) - NXP Semiconductors.

부품명

상세내역

일치하는 목록

TDF8599

I2C-bus controlled dual channel 43 W/2Ωsingle channel 85 W/1Ω class-D power amplifier with load diagnostics

NXP Semiconductors. 

NXP Semiconductors

TDF8599

Class-D power amplifier with load diagnostics

In non-I2C-bus mode pin MOD is used to select:

1. AD or BD modulation type (see Section 8.4.1).

2. 1⁄2 π phase shift when oscillator is used in Slave mode (see Section 8.4.2).

3. Parallel mode operation (see Section 8.4.3).

In I2C-bus mode, pin MOD can only select Parallel mode. In addition, the modulation type

and phase shift are programmed using I2C-bus commands.

Table 8. Operation mode selection with the MOD pin

RMOD (kΩ)

I2C-bus mode

0 (short to GND) Stereo mode

Non-I2C-bus mode

AD modulation: no phase shift in Slave mode

4.7

BD modulation: no phase shift in Slave mode

13

AD modulation: 1⁄2 π phase shift in Slave mode

33

BD modulation: 1⁄2 π phase shift in Slave mode

100

Parallel mode

AD modulation: no phase shift in Slave mode

∞ (open)

BD modulation: no phase shift in Slave mode

The information on pin MOD is latched when one of the TDF8599 outputs starts switching

to avoid incorrect information on pin MOD caused by disturbances of switching amplifier

outputs.

8.4.1 Modulation mode

In non-I2C-bus mode, pin MOD is used to select either AD or BD modulation mode. In

I2C-bus mode, the modulation mode is selected using an I2C-bus command.

• AD modulation mode: the bridge halves switch in opposite phase.

• BD modulation mode: the bridge halves switch in phase but the input signal for the

modulators is inverted.

Figure 10, Figure 11 and Figure 12 show simplified representations of AD and BD

modulation.

INxP

+VP

+VP

OUTP OUTN

INxN

AD

BD

Fig 10. AD/BD modulation switching circuit

001aai778

TDF8599_1

Product data sheet

Rev. 01 — 13 November 2008

© NXP B.V. 2008. All rights reserved.

12 of 52

Share Link: