4-5435166-9(RevB) 데이터 시트보기 (PDF) - Tyco Electronics
부품명
상세내역
일치하는 목록
4-5435166-9 Datasheet PDF : 7 Pages
| |||
DIP Programming Switches (7000 and 7100 Series)
114-1056
2. REFERENCE MATERIAL
2.1. Revision Summary
S Updated document to corporate requirements
S General update to document
S Deleted premium seal information
2.2. Customer Assistance
Reference Base Product Part Number 435802 and Product Code 4546 identify the DIP Programming Switches
(7000 and 7100 series). Use of these numbers will identify the product line and expedite your inquiries through
a service network established to help you obtain product and tooling information. Such information can be
obtained through a local Tyco Electronics Representative or, after purchase, by calling the Tooling Assistance
Center or the Product Information Center number at the bottom of page 1.
2.3. Drawings
Customer drawings for specific products are available from the service network. The information contained in
the customer drawings takes priority if there is a conflict with this specification or with any other technical
documentation supplied by Tyco Electronics. Contact the Product Information Center number at the bottom of
page 1 if such a conflict is encountered.
2.4. Specifications
Product Specifications 108–7519 (7000 series), and 108–7532 (7100 series) provide performance
requirements for DIP Programming Switches. Qualification Test Report 501–135 (7000 series), and 501–128
(7100 series) provides an independent corporate test report to show the switch conforms to the above
mentioned Product Specifications.
2.5. Instructional Material
Instruction Sheet 408–7779 provides installation information and procedures on DIP Programming Switches
(7000 and 7100 Series).
2.6. Manuals
Manual 402–40 can be used as a guide to soldering. This manual provides information on various flux types
and characteristics with the commercial designation and flux removal procedures. A checklist is included in the
manual as a guide for information on soldering problems.
3. REQUIREMENTS
3.1. Safety
Do not stack product shipping containers so high that the containers buckle or deform.
3.2. Limitations
The switches are designed to operate within a temperature range of –55_ to 105_C [–67_ to 221_F].
3.3. Storage
A. Ultraviolet Light
Prolonged exposure to ultraviolet light may deteriorate the chemical composition of components used in
the switches.
B. Shelf Life
The switches should remain in the shipping containers until ready for use to prevent damage. These
products should be used on a first in, first out basis to avoid storage contamination.
C. Chemical Exposure
Do not store switches near any chemicals listed below, as they may cause stress corrosion cracking in the
components.
Alkalies
Amines
Ammonia
Carbonates
Citrates
Nitrites
Phosphates Citrates
Sulfur Nitrites
Sulfur Compounds
Tartrates
2 of 7
Rev B
Share Link: 