4-5435166-9(RevB) 데이터 시트보기 (PDF) - Tyco Electronics
부품명
상세내역
일치하는 목록
4-5435166-9 Datasheet PDF : 7 Pages
| |||
Dual In-Line Package (DIP)
Programming Switches
(7000 and 7100 Series)
Application Specification
114-1056
04 MAY 06 Rev B
NOTE
_ All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2 .
Figures and illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of DIP Programming Switches (7000 and 7100
Series). The 7000 Series switches are designed for a life of 7000 cycles per pole. The 7100 Series switches
are recommended for programming applications where the number of cycles is limited to 2000 per pole.
Switches are manually rocker actuated and are designed for wave soldering on printed circuit (pc) boards or
insertion into DIP Sockets with in–row centerline spacing of 7.62 mm (.300 in.). The 7000 series switches are
black, and are available in 2 through 12 positions, while the 7100 series switches are blue, and are available in
2 through 12 positions. Both series are available with a premium seal, an economy seal, or unsealed in the
raised rocker (standard profile) or flush rocker profile (low profile). In addition, the 7000 series switches are
available with a side rocker profile (side actuated). Both series are individual single–pole, single–throw (SPST).
The 7000 series raised rocker profile switches may have ganged rockers for single–pole, double–throw (SPDT)
and double–pole, double–throw (DPDT) make–before–break circuits.
The unsealed switches are designed for socket applications and the sealed switches are designed for soldering
directly to the pc board. The sealants prevent flux and other contaminants from entering the switch during
soldering and cleaning. The raised rocker and side rocker profiles come unsealed or with an optional economy
or premium masking top seal. The flush rocker profile comes unsealed or with an optional economy tape top
seal or premium masking top seal. The multi–pole switches come unsealed only. All switches come standard
with a bottom seal. Switches are designed for use in logic level switching applications.
When corresponding with Tyco Electronics Personnel, use the terminology provided on this specification to
help facilitate your inquiry for information. Basic terms and features of this product line are provided in Figure 1.
Raised Rocker
Standard Profile Switch
Flush Rocker
Position Number
White Dot Identifies Pin 1
Housing
Side Rocker Switch
Low-Profile Switch
White Dot Identifies Pin 1
Figure 1
Solder Tail
E2006 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
Tyco is a trademark. *Trademark
Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 7
LOC B
Share Link: 