WM8772SEDS/RV 데이터 시트보기 (PDF) - Cirrus Logic

부품명

상세내역

일치하는 목록

WM8772SEDS/RV

24-bit, 192kHz 6-Channel Codec with Volume Control

Cirrus Logic 

WM8772

Production Data

TERMINOLOGY

1. Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full scale output and the output

with no signal applied. (No Auto-zero or Automute function is employed in achieving these results).

2. Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal.

Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB

to it. (e.g. THD+N @ -60dB= -32dB, DR= 92dB).

3. THD+N (dB) - THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.

4. Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).

5. Channel Separation (dB) - Also known as Cross-Talk. This is a measure of the amount one channel is isolated from

the other. Normally measured by sending a full scale signal down one channel and measuring the other.

6. Pass-Band Ripple - Any variation of the frequency response in the pass-band region.

w

PD Rev 4.2 October 2005

12

Share Link: