CMX882 데이터 시트보기 (PDF) - CML Microsystems Plc

부품명

상세내역

일치하는 목록

CMX882

FRS Signalling Processor

CML Microsystems Plc 

FRS Signalling Processor

CMX882

Rx Companding (Expanding)

The CMX882 incorporates an optional syllabic compandor in both transmit and receive modes. This

expands received voice band signals that have been similarly compressed in the transmitter to enhance

dynamic range. The compandor attack, decay and 0dB point are defined in section 1.8.1. See section

1.6.9 for details of how to control this function.

Audio De-Scrambling

The CMX882 incorporates an optional frequency inversion de-scrambler in receive mode. This de-

scrambles received voice band signals that have been scrambled in the transmitter. See section 1.6.9 for

details of how to control this function.

Voice Processing Combinations

Table 1 shows the valid voice processing combinations. (See section 1.5).

1.5.3.2 Receiving and Decoding CTCSS Tones

The CMX882 is able to accurately detect valid CTCSS tones quickly to avoid losing the beginning of

voice or possibly data transmissions, and is able to continuously monitor the detected tone with minimal

probability of falsely dropping out. The received signal is filtered in accordance with the template shown

in Figure 7, to prevent signals outside the sub-audio range from interfering with the sub-audio tone

detection.

10

0

-10

-20

-30

-40

-50

-60

-70

0

200

400

600

800

1000

Frequency (Hz)

Figure 7 Low Pass Sub-Audio Band Filter for CTCSS and DCS

Once a valid CTCSS tone has been detected, the voice band signal can be passed to the audio output.

The voice band signal is extracted from the received signal by band pass filtering as shown in Figure 5.

To help decode received CTCSS tones adjustable decoder bandwidths and threshold levels permit

decode certainty and signal to noise performance to be traded when congestion or range limits the

system performance. This entails setting the tone decoder bandwidth and threshold level in P2.1 of the

Programming register ($C8) and programming the Audio & Tx CTCSS Control register with the desired

tone.

Tone Cloning:

Tone CloningTM facilitates the detection of CTCSS tones 1 to 39 in receive mode. This allows the device

to non-predictively detect any tone in this range. The received tone number will be reported in the Tones

Status register. This tone code can then be programmed into the ‘Audio and Device Address Control’

register, by the host µC. The cloned tone will only be active when CTCSS is enabled in the Mode

register.

 Tone Cloning is a trademark of CML Microsystems Plc.

 2004 CML Microsystems Plc

19

D/882/7

Share Link: