General Information
The TLE4926C-HT E6547 is an active Hall sensor suited to detect the motion and position of ferromagnetic and permanent magnet structures. An additional self-calibration module has been implemented to achieve optimum accuracy during normal running operation. It comes in a three-pin package for the supply voltage and an open drain output.

FEATUREs
• High sensitivity
• Single chip solution
• Symmetrical thresholds
• High resistance to Piezo effects
• South and north pole pre-induction possible
• Low cut-off frequency
• Digital output signal
• Advanced performance by dynamic self calibration principle
• Two-wire and three-wire configuration possible
• Wide operating temperature range
• Fast start-up time
• Large operating air-gaps
• Reverse voltage protection at Vs- PIN
• Short- circuit and over temperature protection of output
• Digital output signal (voltage interface)
• Module style package with two integrated capacitors:
   • 4.7nF between Q and GND
   • 47nF1 between VS and GND: Needed for micro cuts in power supply