INTRODUCTION
The ST7MCx device is member of the ST7 microcontroller family designed for mid-range applications with a Motor Control dedicated peripheral.
All devices are based on a common industrystandard 8-bit core, featuring an enhanced instruction set and are available with FLASH, ROM or FASTROM program memory.
Under software control, all devices can be placed in Wait, Slow, Active-halt or Halt mode, reducing power consumption when the application is in idle or stand-by state.

FEATUREs
■ Memories
   – 8K to 60K dual voltage Flash Program memory or ROM with read-out protection capability, In-application programming and In-circuit programming.
   – 384 to 1.5K RAM
   – HDFlash endurance: 100 cycles, data retention: 40 years at 85°C
■ Clock, reset and supply management
   – Enhanced reset system
   – Enhanced low voltage supervisor (LVD) for main supply and auxiliary voltage detector (AVD) with interrupt capability
   – Clock sources: crystal/ceramic resonator oscillators and by-pass for external clock, clock security system.
   – Four power saving modes: Halt, Active-halt, Wait and Slow
■ Interrupt management
   – Nested interrupt controller
   – 14 interrupt vectors plus TRAP and RESET
   – MCES top level interrupt pin
   – 16 external interrupt lines (on 3 vectors)
■ Up to 60 I/O ports
   – up to 60 multifunctional bidirectional I/O lines
   – up to 41 alternate function lines
   – up to 12 high sink outputs
■ 5 timers
   – Main clock controller with: Real-time base, Beep and clock-out capabilities
   – Configurable window watchdog timer
   – Two 16-bit timers with: 2 input captures, 2 output compares, external clock input, PWM and pulse generator modes
   – 8-bit PWM Auto-reload timer with: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector
■ 2 Communication interfaces
   – SPI synchronous serial interface
   – LINSCI™ asynchronous serial interface
■ Brushless motor control peripheral
   – 6 high sink PWM output channels for sinewave or trapezoidal inverter control
   – Motor safety including asynchronous emergency stop and write-once registers
   – 4 analog inputs for rotor position detection (sensorless/hall/tacho/encoder)
   – Permanent magnet motor coprocessor including multiplier, programmable filters, blanking windows and event counters
   – Operational amplifier and comparator for current/voltage mode regulation and limitation
■ Analog peripheral
   – 10-bit ADC with 16 input pins
■ In-circuit Debug
■ Instruction set
   – 8-bit data manipulation
   – 63 basic instructions with illegal opcode detection
   – 17 main Addressing modes
   – 8 x 8 unsigned multiply instruction
   – True bit manipulation
■ Development tools
   – Full hardware/software development package