Product Description
The PI90LV179, PI90LV180, PI90LV050, and PI90LV051 are differential line drivers and receivers (transceivers) that are compliant with the IEEE 1596.3 SCI and ANSI/TIA/EIA-644 LVDS standards. These devices use low-voltage differential signaling (LVDS) to achieve data rates in excess of 660 Mbps while being less susceptible to noise than single-ended transmission.
The drivers translate a low-voltage TTL/CMOS input into a low voltage (350mV typical) differential output signal. The receivers translate a differential 350mV input signal to a 3V CMOS output level. The driver section can be independently set to a power-down and high-impedance output mode with the DEN pin (active HIGH). The receiver section is controlled by the REN* pin (active LOW).

Product Features
• Signaling Rates >660 Mbps (330 MHz)
• Single 3.3V Power Supply Design
• Driver:
   — ±350mV Differential Swing into a 100-Ohm load
   — Propogation Delay of 1.5ns Typ.
   — Low Voltage TTL (LVTTL) Inputs are 5V Tolerant
   — Driver is High Impedance when Disabled or VCC <1.5V
• Receiver:
   — Accepts ±50mV (min.) Differential Swing with up to 2.0V
      ground potential difference
   — Propagation Delay of 3.3ns Typ.
   — Low Voltage TTL (LVTTL) Outputs
   — Open, Short, and Terminated Fail Safe
• Industrial Temperature Operating Range: –40°C to 85°C
• Package Options: SOIC, TSSOP, MSOP
• Meets or Exceeds IEEE 1596.3 SCI Standard
• Meets or Exceeds ANSI/TIA/EIA-644 LVDS Standard
• Bus-Terminal ESD exceeds 12kV

APPLICATIONs
   Applications include point-to-point and multidrop baseband data transmission over a controlled impedance media of approximately 100 ohms. These include intra-system connections via printed circuit board traces or cables, hubs and routers for data communications; PBXs, switches, repeaters and base stations for telecommunications and other applications such as digital cameras, printers and copiers.