General Description
The NT68F62 is a new generation of monitor µC for autosync and digital control applications. Particularly, this chip supports various functions to allow users to easily develop USB monitors. It contains the 6502 8-bit CPU core, 512 bytes of RAM for use as working RAM and as stack area, 32K bytes of Flash memory, 13-channels of 8-bit PWM D/A converters, 4-channel A/D converters for detection of keys which can save I/O pins, one 8-bit pre-loadable base timer, an internal Hsync and Vsync signals processor and a watch-dog timer, which prevents the system from abnormal operation and two IIC bus interfaces. The user can store EDID data in the 128 bytes of RAM for DDC1/2B, so that the user can reduce a dedicated EEPROM for EDID. The half frequency output function can save the external oneshot circuit.
FEATUREs
◾ Operating voltage range: 4.5V to 5.5V
◾ CMOS technology for low power consumption
◾ 6502 8-bit CMOS CPU core
◾ 8 MHz operation frequency
◾ 32K bytes of flash memory for Multi -Times Program
◾ 512 bytes of RAM
◾ 2Kbytes Masked BootROM for ISP.
◾ One 8-bit base timer
◾ 13 channels of 8-bit PWM outputs with 5V open drain
◾ 4 channel A/D converters with 6-bit resolution
◾ 25 bi-directional I/O port pins (8 dedicated I/O pins)
◾ Hsync/Vsync signals processor for separate &
composite signals, including hardware sync signals
polarity detection and freq. counters with 2 sets of
Hsync counting intervals
◾ Hsync/Vsync polarity controlled output, 5 selectable
free run output signals and self-test patterns,
automute function, half freq. I/O function
◾ Two built-in IIC bus interfaces support VESA
DDC1/2B+
◾ Two layers of interrupt management
NMI interrupt sources
- INTE0 (External INT with selectable edge trigger)
- INTMUTE (Auto Mute Activated)
IRQ interrupt sources
- INTS0/1 (SCL Go-low INT)
- INTA0/1 (Slave Address Matched INT)
- INTTX0/1 (Shift Register INT)
- INTRX0/1 (Shift Register INT)
- INTNAK0/1 (No Acknowledge)
- INTSTOP0/1 (Stop Condition Occurred INT)
- INTE1 (External INT with Selectable Edge Trigger)
- INTV (VSYNC INT)
- INTMR (Base Timer INT)
- INTADC (AD Conversion Done INT)
◾ Hardware watch-dog timer function
◾ 40-pin P-DIP and 42-pin S-DIP packages