DESCRIPTION
The MBM29LV800TE/BE are a 8 M-bit, 3.0 V-only Flash memory organized as 1 M bytes of 8 bits each or 512 Kwords of 16 bits each. The MBM29LV800TE/BE are offered in a 48-pin TSOP (1) , 48-pin CSOP and 48- ball FBGA package. These devices are designed to be programmed in a system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also be reprogrammed in standard EPROM programmers.

FEATURES
• 0.23 µm Process Technology
• Single 3.0 V Read, Program, and Erase
   Minimized system level power requirements
• Compatible with JEDEC-standard Commands
   Use the same software commands as E2PROMs
• Compatible with JEDEC-standard World-wide Pinouts
   48-pin TSOP (1) (Package suffix : TN Normal Bend Type)
   48-pin CSOP (Package suffix : PCV)
   48-ball FBGA (Package suffix : PBT)
• Minimum 100,000 Program/Erase Cycles
• High Performance
   70 ns maximum access time
• Sector Erase Architecture
   One 8 Kwords, two 4 Kwords, one 16 Kwords, and fifteen 32 Kwords sectors in word mode
   One 16 Kbytes, two 8 Kbytes, one 32 Kbytes, and fifteen 64 Kbytes sectors in byte mode
   Any combination of sectors can be concurrently erased, and also supports full chip erase.
• Boot Code Sector Architecture
   T = Top sector
   B = Bottom sector
• Embedded EraseTM* Algorithm
   Automatically pre-programs and erases the chip or any sector.
• Embedded ProgramTM* Algorithm
   Automatically writes and verifies data at specified address.
• Data Polling and Toggle Bit Feature for Detection of Program or Erase Cycle Completion
• Ready/Busy Output (RY/BY)
   Hardware method for detection of program or erase cycle completion
• Automatic Sleep Mode
   When addresses remain stable, MBM29LV800TE/BE automatically switch themselves to low power mode.
• Low VCC Write Inhibit ≤ 2.5 V
• Erase Suspend/Resume
   Suspends the erase operation to allow a read data and/or program in another sector within the same device.
• Sector Protection
   Hardware method disables any combination of sectors from program or erase operations.
• Sector Protection Set Function by Extended Sector Protection Command
• Fast Programming Function by Extended Command
• Temporary Sector Unprotection
   Temporary sector unprotection via the RESET pin