LINE MATCHING AUDIO TRANSFORMERS

• Couple 3.2, 8 or 16 ohm speakers to 25 or 70 volt line outputs of amplifiers.
• Up to 5 power tap levels available (except 117F2 which has 4).
• Primary taps marked in watts (no calculation necessary), to match speaker power.
• Frequency response 100 Hz. to 9 Khz. (1 db. reference @1 Khz.)
• Insertion loss less than 2 db.
• Distortion is less than 1.25% @ 100 Hz. at maximum power.
• Horizontal, channel bracket, 2-hole (.187" dia.) mounting.
• All models have solder lugs, also suitable for slip on jumper connections.
• Total power requirements of speakers should not exceed the rated power of each transformer or rated power of the amplifier.

MATCHING AUTO 25V OR 70V LINE AUDIO TRANSFORMERS

• Suitable for driving from solid state amplifiers where isolated windings are not required or can be used with our "Classic" 1600 tube output transformers to provide a 25V or 70V line output.
• 8 or 16 ohm input, 25V or 70V line output.
• Frequency response 50 Hz. to 10 Khz. at full ratings
• Leads 6" long minimum
• Can be reversed for operation at high power speaker locations.
• For speaker matching from older "classic" equipment check out our 119DA matching transformer.