BR9080AF-W 데이터 시트보기 (PDF) - ROHM Semiconductor

부품명

상세내역

일치하는 목록

BR9080AF-W

8k, 16k bit EEPROMs for direct connection to serial ports

ROHM Semiconductor 

Memory ICs

BR9080AF-W / BR9080ARFV-W / BR9080ARFVM-W /

BR9016AF-W / BR9016ARFV-W / BR9016ARFVM-W

!Operation notes

(1) Turning the power supply on and off

1) When the power supply is turned on and off, CS should be set to HIGH (=VCC).

2) When CS is LOW, the command input reception state (active) is entered. If the power supply is turned on in this state,

erroneous operations and erroneous writing can occur because of noise and other factors. To avoid this, make sure

CS is set to HIGH (=VCC) before turning on the power supply.

(Good example) Here, the CS pin is pulled up to VCC.

When turning off the power supply, wait at least 10msec before turning it on again. Failing to

observe this condition can result in the internal circuit failing to be reset when the power supply is

turned on.

(Bad example) CS is LOW when the power supply is turned on or off.

In this case, because CS remains LOW, the EEPROM may perform erroneous operations or

write erroneous data because of noise or other factors.

* Please be aware that the case shown in this example can also occur if CS input is HIGH-Z.

VCC

VCC

GND

VCC

CS

GND

Good example

Bad example

Fig.9

(2) Noise countermeasures

1) SK noise

If noise occurs at the rise of the SK clock input, the clock is assumed to be excessive, and this can cause malfunction

because the bits are out of alignment.

2) WC noise

During a writing operation, noise at the WC pin can be erroneously judged to be data, and this can cause writing to be

forcibly interrupted.

3) VCC noise

Noise and surges on the power supply line can cause malfunction. We recommend installing a bypass capacitor

between the power supply and ground to eliminate this problem.

10/12

Share Link: