W147G 데이터 시트보기 (PDF) - Cypress Semiconductor
부품명
상세내역
일치하는 목록
W147G Datasheet PDF : 12 Pages
| |||
PRELIMINARY
W147G
W147G
Power-on
Reset
Timer
VDD
Output
Buffer
Output Three-state
Hold
Output
Low
QD
Data
Latch
10 kΩ
(Load Option 1)
10kΩ
(Load Option 0)
Output Strapping Resistor
Series Termination Resistor
Clock Load
Figure 1. Input Logic Selection Through Resistor Load Option
Overview
The W147G is a highly integrated frequency timing generator,
supplying all the required clock sources for an Intel® architec-
ture platform using graphics integrated core logic.
Functional Description
I/O Pin Operation
REF/APICDIV is a dual purpose l/O pin. Upon power-up the
pin acts as a logic input. If the pin is strapped to a LOW state
externally, APIC clock outputs will run divide synchronously at
half PCI clock speed. If it is pulled HIGH, APIC clock will run
synchronous to PCI clocks. An external 10-kΩ strapping resis-
tor should be used. Figure 1 shows a suggested method for
strapping resistor connections.
After 2 ms, the pin becomes an output. Assuming the power
supply has stabilized by then, the specified output frequency
is delivered on the pins. If the power supply has not yet
reached full value, output frequency initially may be below tar-
get but will increase to target once supply voltage has stabi-
lized. In either case, a short output clock cycle may be pro-
duced from the CPU clock outputs when the outputs are
enabled.
Pin Selectable Functions
Table 1 outlines the device functions selectable through
SEL0:1. Specific outputs available at each pin is detailed in
Table 2 below. The SEL0 pin requires a 220Ω pull-up resistor
to 3.3V for the W147G to sense the maximum host bus fre-
quency of the processor and configure itself accordingly.
Table 2. CK Whitney Truth Table
SEL1 SEL0
CPU
SDRAM
3V66
PCI
48MHz
REF
0
0
Hi-Z
Hi-Z
Hi-Z
Hi-Z
Hi-Z
Hi-Z
0
1
TCLK/2 TCLK/2 TCLK/3 TCLK/6 TCLK/2
TCLK
1
0
66 MHz 100 MHz 66 MHz 33 MHz 48 MHz 14.318 MHz
1
1
100 MHz 100 MHz 66 MHz 33 MHz 48 MHz 14.318 MHz
Notes:
1. APIC clock frequency determined by the strap option on the REF/APICDIV input pin.
2. Provided for board level “bed of nails” testing.
3. “Normal” mode of operation.
4. TCLK is a test clock overdriven on the XTAL_IN input during test mode.
5. Required for DC output impedance verification.
6. Range of reference frequency allowed is: min. = 14.316 MHz, nominal = 14.31818 MHz, max. = 14.32 MHz.
7. Frequency accuracy of 48 MHz must be +167 PPM to match USB default.
APIC[1]
Hi-Z
TCLK/6
16.67 MHz
16.67 MHz
Notes
2
4, 5
3, 6, 7
3, 6, 7
3
Share Link: 