DG502U 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

일치하는 목록

DG502U

2-DOOR CONTROLLER 500 USERS

Unspecified 

Edition 12/2005

Note: the time outputs and the enrolment reader are not set to their default settings.

Relay Outputs

Badge 1 – Access Level 01

Badge 2 – Access Level 02

relays

Badge 3 – Access Level 03

Controller built-in reader activates relay 1

Remote reader 1 activates relay 1

Controller built-in reader activates no

Remote reader 2 activates relay 2

Controller built-in reader activates relay 1

Remote reader 1 activates relay 1

Remote reader 2 activates relay 2

Reset to Factory Default Values

Cut the power on the DG502 unit

Place the jumper on ST1, 2-3 position

Power on the DG502, the LED is still off

Remove the jumper from ST1, 2-3 position, the LED flashes orange

Wiring of the Remote Readers

Follow the schematic on page 1 to connect remote reader 1 to the controller. Connect terminals 2, 3, 4,

5, 12 and V from the controller directly to the terminals on the remote reader 1. Terminal 6 on the

controller is connected to terminal 1 of remote reader 1.

For remote reader 2, connect in parallel terminals 2, 3, 4, 5, 12 and V from the controller unit. Terminal 1

on the controller is connected to terminal 1 of remote reader 2.

To power the remote readers use a different power supply or use the 12V output from the

controller (At the right hand completely it is the inputs 12V of the controller. The 12V at

the left of the other 12V is the output).

5

Share Link: