DG502U 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

일치하는 목록

DG502U

2-DOOR CONTROLLER 500 USERS

Unspecified 

Edition 12/2005

Change the Master Code

1. Enter the master code twice (for the first use the master code default value

is 12345). 2 beeps and the orange LED lights on confirming that you are in

programming mode.

2. Enter *3 then the 5-digit new master code. The LED goes off during 1 second

and an audible beep indicates that the new master code is memorised.

3. Press # to exit from the programming mode. 2 beeps confirm that you went

back to the reading mode.

4 beeps indicate a data computing error.

Time outputs, Enrolment Reader and Access Level

Enter the master code twice (for the first use the master code default value is

12345). 2 beeps and the orange LED lights on confirm the entry in programming

mode.

Enrolment reader

Time output relay 1

Enter 0, then 00 to select the built-in reader of the controller as the

enrolment unit.

Press 0, then 01 remote reader 1 as the enrollment unit.

The LED lights off during 1 second and an audible beep indicates

the validation of the enrolment reader.

In stand-by mode, if the enrolment reader is the controller

built-in reader all the readers can be used but if the enrolment

reader is the remote reader 1 then only the 2 remote reader can

be used.

Enter 1, then the time relay in second:

01 equal 1 second up to 99 for 99 seconds.

00 corresponds to a latched output.

The LED lights off during 1 second and an audible beep indicates

the validation of the time delay.

Time output relay 2

Access Level

Enter 2, then the time relay in second:

01 equal 1 second up to 99 for 99 seconds.

00 corresponds to a latched output.

The LED lights off during 1 second and an audible beep indicates

the validation of the time delay.

Enter 4 , then 01 for door 1 and controller activates relay 1

02 for door 2

activates relay 2

03 door 1 and 2

activates relay 1 2

The LED lights off during 1 second and an audible beep indicates

the validation of the access level.

Press # to exit from the programming mode. 2 beeps confirm that you returned

to reading mode.

4 beeps indicate a data computing error.

3

Share Link: