ST7586S 데이터 시트보기 (PDF) - Sitronix Technology Co., Ltd.
부품명
상세내역
일치하는 목록
ST7586S Datasheet PDF : 63 Pages
| |||
ST7586S
PIN DESCRIPTION
Power System
Name
Type
VDD1 Power
VDD2~5 Power
VDDX Power
VSS1
VSS2
VSS4
VSSX
Power
Power
Power
VD1S
Input
Description
VDD1 is the power of interface I/O circuit.
VDD2 is the analog power for internal booster. VDD3~5 are the analog power for LCD driver.
VDD2~5 and VDDX are separated in ITO and connected together by FPC or PCB.
Digital power for OSC circuit.
VDD2~5 and VDDX are separated in ITO and connected together by FPC or PCB.
Ground of interface, logic (VSS1) and OSC (VSSX) circuits.
Ground system should be connected together by FPC or PCB.
Ground of booster (VSS2) and LCD (VSS4) driver.
Ground system should be connected together by FPC or PCB.
Ground of OSC circuit.
Ground system should be connected together by FPC or PCB.
Digital power source selection.
VD1S = “L”: the power source of digital circuit is VDD1.
VD1S = “H”: the power source of digital circuit is internal regulator.
VDD1 (TYP.) Cap. of VD1 and VSS Level of VD1S
1.8
Unnecessary
VSS1
2.8
Necessary
VDD1
3.0
Necessary
VDD1
3.3
Necessary
VDD1
VD1I
VD1O
V0O
V0I
V0S
XV0O
XV0I
XV0S
Power
Power
Power
Input
Power
Power
Input
VD1I is the power source of digital circuits.
VD1O is the VD1 output. VD1I and VD1O should be connected together by FPC or PCB.
Positive operating voltage of COM-drivers.
V0O is the output of the positive Vop generator.
V0I is the positive Vop supply of LCD drivers.
V0S is the sensor of the positive Vop generator.
V0O, V0I & V0S should be separated on ITO and be connected together by FPC.
Negative operating voltage of COM-drivers.
XV0O is the output of the negative Vop generator.
XV0I is the negative Vop supply of LCD drivers.
XV0S is the sensor of the negative Vop generator.
XV0O, XV0I & XV0S should be separated on ITO and be connected together by FPC.
VGO
VGI
VGS
VM
Power
Power
Input
Power
VG is the power of SEG-drivers. VM is the non-select voltage level of COM-drivers.
VGO is the output of the VG regulator.
VGI is the supply of SEG-drivers.
VGS is the sensor of the VG regulator.
VGO, VGI & VGS should be separated on ITO and be connected together by FPC.
Be sure the relationships (as shown below) among the LCD driving voltages:
V0 ≥ VG ≥ VM ≥ VSS ≥ XV0; VDDA-0.7 ≥ VM ≥ 0.9V; and 2*VDDA-0.7 ≥ VG ≥ 1.8V
When this IC is operating, VG and VM are generated according to the bias setting shown below:
LCD Bias
VG
VM
1/N Bias
(2/N) x V0
(1/N) x V0 Note: N = 9~14
Ver-1.1a
12/63
2009/11/30
Share Link: 