datasheetbank_Logo
전자부품 반도체 검색엔진( 무료 PDF 다운로드 ) - 데이터시트뱅크

PS11017 데이터 시트보기 (PDF) - Powerex

부품명
상세내역
일치하는 목록
PS11017 Datasheet PDF : 6 Pages
1 2 3 4 5 6
PRELIMINARY NSootmicee:pTahriasmisetnroict laimfiintsalasrepescuibficjeacttiotno.change.
MITSUBISHI SEMICONDUCTOR <Application Specific Intelligent Power Module>
PS11017
FLAT-BASE TYPE
INSULATED TYPE
ELECTRICAL CHARACTERISTICS (Tj = 25°C, VDH = 15V, VDB = 15V unless otherwise noted)
Symbol
fPWM
txx
tdead
Item
PWM input frequency
Allowable input on-pulse width
Allowable input signal dead time for
blocking arm shoot-through
Condition
Ratings
Min.
Typ.
Max. Unit
TC 100°C, Tj 125°C
15
kHz
VDH = 15V, TC = –20°C ~ +100°C (Note 3)
1
500
µs
Relates to corresponding inputs,
(Except brake part), TC = –20°C ~ +100°C
2.5
µs
tint
Input inter-lock sensing
Relates to corresponding input (Except break part) —
65
100
ns
VCO
Ic = 0A
VDH = 15V
1.87 2.27 2.57
V
VC+(200%) Analogue signal linearity with output current Ic = IOP(200%)
TC = –20°C ~ 100°C
0.77
1.17
1.47
V
VC–(200%)
Ic = –IOP(200%)
(Fig. 4) 2.97 3.37 3.67
V
|VCO| Offset change area vs temperature
VDH = 15V, TC = –20°C ~ 100°C
15
mV
VC+
Ic > IOP(200%), VDH = 15V
VC–
Analogue signal output voltage limit
0.7
V
(Fig. 4) 4.0
V
VC(200%) Analogue signal over all linear variation |VCO-VC±(200%)|
1.1
V
rCH
Analogue signal data hold accuracy
Correspond to max. 500µs data hold period
only, Ic = IOP(200%)
(Fig. 5)
–5
5
%
td(read)
Analogue signal reading time
After input signal trigger point
(Fig. 8) —
3
µs
ICL(H)
ICL(L)
±IOL
SC
OT
OTr
UVDH
Signal output current of
CL operation
Idle
Active
Open collector output
1
µA
1
mA
CL warning operation level
VD = 15V, TC = –20°C ~ 100°C
(Note 4) 48.2 60.0 72.0
A
Short circuit over current trip level
Tj = 25°C
(Fig. 7) (Note 5) 79.2
102
A
Over temperature
protection
Trip level
VDH = 15V
Reset level
100
110
120
°C
90
°C
Trip level
11.05 12.00 12.75 V
UVDHr
OVDH
OVDHr
UVDB
UVDBr
tdV
IFO(H)
IFO(L)
Supply circuit under &
over voltage protection
Fault output current
Reset level
Trip level
Reset level
Trip level
Reset level
Filter time
Idle
Active
TC = –20 ~ +100°C,
Tj 125°C
Open collector output
11.55 12.50 13.25
V
18.00 19.20 20.15 V
16.50 17.50 18.65 V
10.0 11.0 12.0
V
10.5 11.5 12.5
V
10
µs
1
µA
1
mA
(Note 3) : (a) Allowable minimum input on-pulse width : This item applies to P-side circuit only.
(b) Allowable maximum input on-pulse width : This item applies to both P-side and N-side circuits excluding the brake circuit.
(Note4) : CL output : The "current limit warning (CL) operation circuit outputs warning signal whenever the arm current exceeds this limit. The
circuit is reset automatically by the next input signal and thus, it operates on a pulse-by-pulse scheme.
(Note5) : The short circuit protection works instantaneously when a high short circuit current flows through an internal IGBT rising up momen-
tarily. The protection function is, thus meant primarily to protect the ASIPM against short circuit distraction. Therefore, this function is
not recommended to be used for any system load current regulation or any over load control as this might, cause a failure due to
excessive temperature rise. Instead, the analogue current output feature or the over load warning feature (CL) should be appropri-
ately used for such current regulation or over load control operation. In other words, the PWM signals to the ASIPM should be shut
down, in principle, and not to be restarted before the junction temperature would recover to normal, as soon as a fault is feed back
from its FO1 pin of the ASIPM indicating a short circuit situation.
RECOMMENDED CONDITIONS
Symbol
Item
VCC
Supply voltage
VDH, VDB Control Supply voltage
VDH, VDB
VCIN(on)
VCIN(off)
fPWM
tdead
Supply voltage ripple
Input on voltage
Input off voltage
PWM Input frequency
Arm shoot-through blocking time
Condition
Applied across P-N terminals
Applied between VDH-GND, CBU+-CBU–, CBV+-CBV–,
CBW+-CBW–
Using application circuit
Using application circuit
Ratings
Unit
400 (max.)
V
15±1.5
V
±1 (max.)
V/µs
0 ~ 0.3
V
4.8 ~ 5.0
V
2 ~ 15
kHz
2.5 (min.)
µs
Jan. 2000

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]