MC9S08QA2(2008) 데이터 시트보기 (PDF) - Freescale Semiconductor
부품명
상세내역
일치하는 목록
MC9S08QA2 Datasheet PDF : 32 Pages
| |||
Electrical Characteristics
6 Input must be current-limited to the value specified. To determine the value of the required current-limiting resistor, calculate
resistance values for positive and negative clamp voltages, then use the larger of the two values.
7 Power supply must maintain regulation within operating VDD range during instantaneous and operating maximum current
conditions. If positive injection current (VIn > VDD) is greater than IDD, the injection current may flow out of VDD and could result
in external power supply going out of regulation. Ensure external VDD load will shunt current greater than maximum injection
current. This will be the greatest risk when the MCU is not consuming power. Examples are: if no system clock is present, or if
clock rate is very low (which would reduce overall power consumption).
40
PULLUP RESISTOR TYPICALS
85°C
25°C
–40°C
35
PULLDOWN RESISTOR TYPICALS
40
85°C
25°C
–40°C
35
30
30
25
25
20
1.8 2 2.2 2.4 2.6 2.8 3 3.2 3.4 3.6
VDD (V)
20
1.8
2.3
2.8
VDD (V)
3.3 3.6
Figure 3. Pullup and Pulldown Typical Resistor Values (VDD = 3.0 V)
1.2
1
0.8
0.6
0.4
0.2
0
0
TYPICAL VOL VS IOL AT VDD = 3.0 V
85°C
25°C
–40°C
TYPICAL VOL VS VDD
0.2
0.15
0.1
0.05
85°C, IOL = 2 mA
25°C, IOL = 2 mA
0
–40°C, IOL = 2 mA
5
10
15
20
IOL (mA)
1
2
3
4
VDD (V)
Figure 4. Typical Low-Side Driver (Sink) Characteristics — Low Drive (PTxDSn = 0)
1
0.8
0.6
0.4
0.2
0
0
85°C
25°C
–40°C
TYPICAL VOL VS IOL AT VDD = 3.0 V
TYPICAL VOL VS VDD
0.4
85°C
25°C
0.3
–40°C
10
20
IOL (mA)
0.2
0.1
0
30
1
IOL = 6 mA
IOL = 3 mA
2
3
VDD (V)
IOL = 10 mA
4
Figure 5. Typical Low-Side Driver (Sink) Characteristics — High Drive (PTxDSn = 1)
MC9S08QA4 Series, Rev. 2
Freescale Semiconductor
9
Share Link: 