HC1-5509A1-5 데이터 시트보기 (PDF) - Intersil
부품명
상세내역
일치하는 목록
HC1-5509A1-5 Datasheet PDF : 10 Pages
| |||
Specifications HC-5509A1
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at TA = +25oC, Min-Max Parameters are over
Operating Temperature Range, VB- = -48V, VB+ = +5V, AG = DG = BG = 0V. All A.C. Parameters are
specified at 600Ω 2-Wire terminating impedance. (Continued)
PARAMETER
TEST CONDITIONS
MIN
TYP MAX UNITS
Relay Driver Outputs
On Voltage VOL
Off Leakage Current
TTL/CMOS Logic Inputs (F0, F1, RS, TEST,
PRI)
IOL (PR) = 60mA, IOL (RD) = 30mA
VOH = 13.2V
-
0.2
0.5
V
-
±10
±100
µA
Logic ‘0’ VIL
Logic ‘1’ VIH
Input Current (F0, F1, RS, TEST, PRI)
Logic Outputs
0V ≤ VIN ≤ 5V
-
-
0.8
V
2.0
-
5.5
V
-
-
±100
µA
Logic ‘0’ VOL
Logic ‘1’ VOH
Power Dissipation On Hook
IB+
IB-
UNCOMMITED OP AMP PARAMETERS
ILOAD = 800µA
ILOAD = 40µA
Relay Drivers Off
VB+ = +5.25V, VB- = -58V, RLOOP = ∞
VB+ = +5.25V, VB- = -58V, RLOOP = ∞
-
0.1
0.5
V
2.7
-
-
V
-
200
-
mW
-
-
6
mA
-6
-
-
mA
Input Offset Voltage
-
±5
-
mV
Input Offset Current
-
±10
-
nA
Differential Input Resistance
(Note 2)
-
1
-
MΩ
Output Voltage Swing
Small Signal GBW
RL = 10kΩ
(Note 2)
-
±3
-
VP-P
-
1
-
MHz
NOTES:
1. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Func-
tional operability under any of these conditions is not necessarily implied.
2. May Be Extended to 1900Ω With Application Circuit.
3. These parameters are controlled by design or process parameters and are not directly tested. These parameters are characterized upon
initial design release, upon design changes which would affect these characteristics, and at intervals to assure product quality and spec-
ification compliance.
Pin Descriptions
DIP/SOIC
1
2
3
4
PLCC
2
3
4
8
SYMBOL
DESCRIPTION
AG
Analog Ground - To be connected to zero potential. Serves as a reference for the transmit output
and receive input terminals.
VB+
Positive Voltage Source - Most Positive Supply.
C1
Capacitor #C1 - An external capacitor to be connected between this terminal and analog ground.
Required for proper operation of the loop current limiting function.
F1
Function Address #1 - A TTL and CMOS compatible input used with F0 function address line to
externally select logic functions. The three selectable functions are mutually exclusive. See Truth
Table on page1. F1 should be toggled high after power is applied.
8-134
Share Link: 