MAX126ACAX 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

일치하는 목록

MAX126ACAX

2x4-Channel, Simultaneous-Sampling 14-Bit DAS

Maxim Integrated 

2x4-Channel, Simultaneous-Sampling

14-Bit DAS

CH_A

5k

CIN

S1A

5k

BUFFER

HOLD

CHOLD

7pF

S2A

TRACK

S3A

HOLD

TRACK

FROM MICROSEQUENCER

MUX

CH_B

5k

CIN

5k

S1B

S2B

S3B

REFOUT

DAC

MAX125

SAR

MAX126

Figure 3. Equivalent Input Circuit

signal, and the programmed mode. The T/H amplifiers

hold the input voltages at the CONVST rising edge.

Additional CONVST pulses are ignored until the last

conversion for the sample is complete. The ADC con-

verts each assigned channel in 3µs and stores the

result in an internal 4x14-bit memory.

At the end of the last conversion, INT goes low and the

T/H amplifiers begin to track the inputs again. The data

can be accessed by applying successive pulses to the

RD pin. Successive reads access data words sequen-

tially. The memory is not random-access; data from

CH1 is always read first. After accessing all pro-

grammed channels, the address pointer selects CH1

again. Additional read pulses cycle through the data

words. CS can be held low during successive reads.

Input Bandwidth

The T/H’s input tracking circuitry has an 8MHz small-

signal bandwidth, so it is possible to digitize high-

speed transient events and measure periodic signals

with bandwidths exceeding the ADC’s sampling rate by

using undersampling techniques. To avoid high-

frequency signals being aliased into the frequency

band of interest, anti-alias filtering is recommended.

Analog Input Range and Input Protection

The MAX125’s input range is ±5V, and the MAX126’s

input range is ±2.5V. The input resistance for both parts

is 10kΩ. An input protection structure allows input volt-

ages to ±17V without harming the IC. This protection is

also active in shutdown mode.

Track/Holds

The MAX125/MAX126 feature four simultaneous T/Hs.

Each T/H has two multiplexed inputs. A T-switch input

configuration provides excellent hold-mode isolation.

Allow 1µs acquisition time for 14-bit accuracy.

The T/H aperture delay is typically 10ns. The 500ps

aperture-delay mismatch between the T/Hs allows the

relative phase information of up to four different inputs

to be preserved. Figure 3 shows the equivalent input

circuit, illustrating the ADC’s sampling architecture.

Only one of four T/H stages with its two multiplexed

inputs (CH_A and CH_B) is shown. All switches are in

track configuration for channel A. An internal buffer

charges the hold capacitor to minimize the required

acquisition time between conversions. The analog input

appears as a 10kΩ resistor in parallel with a 16pF

capacitor.

8 _______________________________________________________________________________________

Share Link: