TC58DVM72A1F 데이터 시트보기 (PDF) - Toshiba
부품명
상세내역
일치하는 목록
TC58DVM72A1F Datasheet PDF : 34 Pages
| |||
TC58DVM72A1FT00/ TC58DVM72F1FT00
TC58DAM72A1FT00/ TC58DAM72F1FT00
Read Mode (3)
Read mode (3) has the same timing as Read modes (1) and (2) but is used to access information in the extra
16-byte redundancy area of the page. The start pointer is therefore set to a value between byte 512 and byte 527.
CLE
CE
WE
ALE
RE
RY/BY
Busy
50H
A0~A3
512
527
Figure 5. Read mode (3) operation
Addresses bits A0~A3 are used to set the start pointer for the
redundant memory cells, while A4~A7 are ignored.
Once a 50H command has been issued, the pointer moves to
the redundant cell locations and only those 16 cells can be
addressed, regardless of the value of the A4-to-A7 address. (An
00H command is necessary to move the pointer back to the
0-to-511 main memory cell location.)
X8 : m=527 , n=512
X16 : m=263 , n=256
Sequential Read(1)(2)(3)
This mode allows the sequential reading of pages without additional address input.
00H
01H
Address input
tR
RY/BY
(00H)
0
Busy
m
Data output
(01H) n/2
tR
Busy
Data output
(50H)
tR
Busy
nm
A
A
A
Sequential Read (1)
Sequential Read (2)
Sequential Read (3)
Sequential Read modes (1) and (2) output the contents of addresses 0~m as shown above, while Sequential Read
mode (3) outputs the contents of the redundant address locations only. When the pointer reaches the last address,
the device continues to output the data from this address ** on each RE clock signal.
X8 : m=527,n=512
X16 : m=263,n=256
2003-01-24 20/34
Share Link: 