Revision 0.3
MultiMediaCardTM
5.4.4 Bus Signal Levels
As the bus can be supplied with a variable supply voltage, all signal levels are related to the supply voltage.
V
input
high level
input
low level
VDD
output
VOH
high level
VIH
VIL
undefined
VOL
VSS
t
Figure 5-4 : Bus Signal Levels
output
low level
5.4.5 Open-Drain Mode Bus Signal Level
Parameter
Symbol
Min
Max.
Output HIGH voltage
Output LOW voltage
VOH
VDD-0.2
VOL
0.3
Table 5-6 : Open Drain Mode Bus Signal Levels
The input levels are identical with the push-pull mode bus signal levels.
Unit
V
V
Conditions
IOH = -100 µA
IOL = 2 mA
5.4.6 Push-Pull Mode Bus Signal Level - High Voltage MultiMediaCard
To meet the requirements of the JEDEC specification JESD8-1A, the card input and output voltages shall be within the fol-
lowing specified ranges for any VDD of the allowed voltage range:
Parameter
Output HIGH voltage
Output LOW voltage
Input HIGH voltage
Input LOW voltage
Symbol
VOH
VOL
VIH
VIL
Min
0.75*VDD
0.625*VDD
VSS-0.3
Max.
0.125*VDD
VDD + 0.3
0.25*VDD
Unit
V
V
V
V
Conditions
IOH=-100 µA @VDD min
IOL=100 µA @VDD min
Table 5-7 : Push-Pull Mode Bus Signal Level - High Voltage MulultiMediaCard
5.4.7 Push-Pull Mode Bus Signal Level - Dual Voltage MultiMediaCard
The definition of the I/O signal levels for the Dual voltage MultiMediaCard changes as a function of VDD
2.7V - 3.6V: Identical to the High Voltage MultiMediaCard (refer to Chapter above)
1.95 - 2.7V: Undefined. The card is not operating at this voltage range
1.65 - 1.95V: Compatible with EIA/JEDEC Standard “EIA/JESD8-7 Wide Range” as defined in the following table
20
Sep.22.2005