050-624-5526899 데이터 시트보기 (PDF) - ITT Cannon

부품명

상세내역

일치하는 목록

050-624-5526899

RF Coaxial Connectors

ITT Cannon  

RF Coaxial Connectors

Assembly Instructions

AI-507 & AI-521 SMA Straight Connectors, Solderless Type for Semi-Rigid Cable

1. Trim cable to dimensions shown. Be careful not to nick center conductor. Ensure dielectric is flush.

Remove burrs from the copper jacket end. Pointing of the center conductor is essential.

Assembly Instruction No.

AI 507

AI 521

AI 521

Part Number

055-624-6703890

055-607-6702890

055-607-6203890

A

2,16 ± 0,13 (.085 ± .005)

1,78 ± 0,13 (.085 ± .005)

2,16 ± 0,13 (.085 ± .005)

2. Slide front body assembly onto cable. Firmly seat the clamp body collet on end of cable. Place

assembly into tool 050-000-0130000 with cable in holding jaws and cable end in piston die.

Squeeze tool handles fully and release.

Alternatively

3. Slide front body assembly onto cable, then slide cable into rear end of clamp body until it seats

firmly in counterbore.

NOTE: Where the separate contact versions are used the clamp body should be held securely in

any standard SMA jack to avoid undue pressure on the center contact. The center conductor

Assy Insts

should click into place as it overcomes tension on the tynes.

4. Push front body assembly up over the clamp body then holding cable securely in counterbore, and

using any standard SMA jack as shown, complete assembly by simply tightening mating jack with

a torque of 0.79 to 1.13 Nm (7 to 10 in. lbs.).

Dimensions are shown in mm (inch)

Dimensions subject to change 123

Share Link: