datasheetbank_Logo
전자부품 반도체 검색엔진( 무료 PDF 다운로드 ) - 데이터시트뱅크

CH1782A 데이터 시트보기 (PDF) - Cermetek Microelectronics

부품명
상세내역
일치하는 목록
CH1782A
Cermetek
Cermetek Microelectronics Cermetek
CH1782A Datasheet PDF : 19 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Cermetek Microelectronics, Inc.
CH1782A Family of Ultra Small Modem Modules V.22bis-2400bps
PIN NAME I/O
Table 3. CH1782A Pin Description Continuation.
FUNCTION
9 TIP I/O TIP. Directly connects to the telephone line’s Tip lead through a user supplied RJ-11C jack.
10 RING I/O RING. Directly connects to the telephone line’s Ring lead through a user supplied RJ-11C
jack.
11 RI
O RING INDICATION. This signal follows the frequency of the ringing signal and is normally
about 20 to 40 Hz for 2 seconds on with 4 seconds off.
12 V/D
O VOICE/DATA. Used to switch between telephone and modem line use. In a typical
application, V/D active HIGH opens the normally closed voice injection relay and
disconnects the handset from the telephone line. HIGH indicates the CH1782A is off-hook
and online. Therefore, this pin also reflects the state of the off-hook relay of the CH1782A.
See Figure 2.
13 CTS
14 RST(1)
O CLEAR TO SEND. Output always LOW. Reserved for flow control when using FAX option.
CTS only active on CH1782A when S24=255.
I RESET. Active HIGH. This input must be asserted HIGH for at least 10 ms to reset the
modem. RESET is then returned LOW for normal operation. If no system reset is available,
let this pin float to enable internal reset.
15 HS
O SPEED INDICATION. HIGH speed select output. A low on this pin indicates the modem is
operating at 2400bps.
16 TXD
I TRANSMIT DATA. Serial Transmit data input. Marking or a binary 1 condition is transmitted
when a HIGH is asserted.
17
-
NC NO CONNECTION.
18
-
NC NO CONNECTION.
19
-
NC NO CONNECTION.
20 SPK O SPEAKER. Audio output for speaker. See speaker control schematic in Figure 6.
21
-
NC NO CONNECTION.
NOTE
If the VCC power supply has a slow power up ramp time, the internal reset may be ineffective. In this case, use
an external reset to cycle the VCC to perform the reset function.
2002 Cermetek Microelectronics, Inc.
Page 7
Document No. 607-0009 Revision C (01/03)

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]