HD74CDC2510B 데이터 시트보기 (PDF) - Hitachi -> Renesas Electronics

부품명

상세내역

일치하는 목록

HD74CDC2510B

3.3-V Phase-lock Loop Clock Driver

Hitachi -> Renesas Electronics 

HD74CDC2510B

3.3-V Phase-lock Loop Clock Driver

ADE-205-219G (Z)

8th. Edition

June 2000

Description

The HD74CDC2510B is a high-performance, low-skew, low-jitter, phase-lock loop clock driver. It uses a

phase-lock loop (PLL) to precisely align, in both frequency and phase, the feedback (FBOUT) output to the

clock (CLK) input signal. It is specifically designed for use with synchronous DRAMs. The

HD74CDC2510B operates at 3.3 V VCC and is designed to drive up to five clock loads per output.

Bank of outputs provide ten low-skew, low-jitter copies of the input clock. Output signal duty cycles are

adjusted to 50 percent independent of the duty cycle at the input clock. Bank of outputs can be enabled or

disabled via the control (G) inputs. When the G inputs are high, the outputs switch in phase and frequency

with CLK; when the G inputs are low, the outputs are disabled to the logic-low state.

Unlike many products containing PLLs, the HD74CDC2510B does not require external RC networks. The

loop filter for the PLL is included on-chip, minimizing component count, board space, and cost.

Because it is based on PLL circuitry, HD74CDC2510B requires a stabilization time to achieve phase lock

of the feedback signal to the reference signal. This stabilization time is required, following power up and

application of a fixed-frequency, fixed-phase signal at CLK, as well as following any changes to the PLL

reference or feedback signals. The PLL can be bypassed for test purposes by strapping AVCC to ground.

Features

• Meets “PC SDRAM registered DIMM design support document, Rev. 1.2”

• Phase-lock loop clock distribution for synchronous DRAM applications

• External feedback (FBIN) pin is used to synchronize the outputs to the clock input

• No external RC network required

• Support spread spectrum clock (SSC) synthesizers

Note: Only by a change of a suffix (A to B) for standardization, there isn’t any change of the product.

Share Link: