MA730(2017) 데이터 시트보기 (PDF) - Monolithic Power Systems

부품명

상세내역

일치하는 목록

MA730
(Rev.:2017)

MagAlpha Communication Kit

Monolithic Power Systems 

EVKT-MACOM – MAGALPHA COMMUNICATION KIT

MAGALPHA COMMUNICATION KIT SETUP

Follow the steps below to set up the MagAlpha communication kit.

1. Install Macom Application Software

To find the Macom app, visit the Position Sensors Design Support page on the Monolithic Power

Systems website (www.monolithicpower.com).

2. Configure the LPC-Link2 Board in Flash Boot Mode

Plug the jumper onto JP1 to configure the microcontroller in flash boot mode (see Figure 12). In this

mode, the microcontroller loads the firmware binary stored in the flash.

Figure 12: Configure LPC-Link2 in Flash Boot Mode

3. Plug Connector Board onto the LPC-Link2

carefully Plug the desired connector board to the LPC-Link2 (See Figure 13). Ensure that the female

headers are correctly aligned with the LPC-Link2 pins before connecting the two boards together (see

Figure 14).

Figure 13: Plug Connector Board to the LPC-Link2

Figure 14: Assembled LPC-Link2 with TBMA-CONN Daughter Board

EVKT-MACOM

www.MonolithicPower.com

10

3/15/2017

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

Share Link: