MAX382EWN 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
일치하는 목록
MAX382EWN Datasheet PDF : 12 Pages
| |||
Low-Voltage, 8-Channel/Dual 4-Channel
Multiplexers with Latchable Inputs
______________________________________________________________Pin Description
PIN
MAX382
MAX384
1
1
2, 16, 17
—
—
2, 17
3
3
4
4
5–8
—
NAME*
WR
A0, A2, A1
A0, A1
EN
V-
NO1–NO4
FUNCTION
WRITE Logic Input
Address Logic Inputs (see Truth Tables at end of data sheet)
Address Logic Inputs (see Truth Tables at end of data sheet)
Enable Logic Input (see Truth Tables at end of data sheet)
Negative Supply Voltage Input. Connect to GND for single-supply operation.
Analog Signal Inputs—bidirectional
—
9
—
10–13
5–8
—
9, 10
—
NO1A–NO4A
COM
COMA, COMB
NO8–NO5
Analog Signal Inputs—bidirectional
Analog Signal Output—bidirectional
Analog Signal Outputs—bidirectional
Analog Signal Inputs—bidirectional
—
11–14
NO4B–NO1B Analog Signal Inputs—bidirectional
14
15
V+
Positive Supply Voltage Input
15
16
GND
Ground
18
18
RS
RESET Logic Input
*Analog inputs and outputs are names of convenience only. Inputs and outputs are identical and interchangeable.
__________Applications Information
The internal structures of the MAX382/MAX384 include
translators for the A2/A1/EN/WR/RS digital inputs, latch-
es, and a decode section for channel selection (see
Truth Tables). The analog-signal switches consist of
parallel combinations of N and P MOSFETs.
WRITE (WR) and RESET (RS) strobes are provided for
interfacing with µP-bus lines, alleviating the need for the
µP to provide constant address inputs to the mux to
hold a particular channel (Figures 2–7).
When the WR strobe is in the low state (less than 0.8V)
and the RS strobe is in the high state (greater than
2.4V), the muxes are in the transparent mode—they
act similar to nonlatching devices, such as the
MAX398/MAX399.
When the WR goes high, the previous BCD address
input is latched and held in that state indefinitely.
RS turns off all channels when it is low. All switches stay
off until RS and EN are high and WR is low.
The MAX382/MAX384 work with both single and dual
supplies and function over the +2.4V to +16V single-
supply range. For example, with a single +5V power
supply, analog signals in the 0V to +5V range can be
switched normally. If negative signals around 0V are
expected, a negative supply is needed.
The EN latch allows all switches to be turned off under
program control. This is useful when two or more are
cascaded to build 16-line and larger analog-signal mul-
tiplexers.
_______________________________________________________________________________________ 7
Share Link: 