ICS853111AV 데이터 시트보기 (PDF) - Integrated Device Technology

부품명

상세내역

일치하는 목록

ICS853111AV

LOW SKEW, 1-TO-9 DIFFERENTIAL-TO-3.3V LVPECL/ECL FANOUT BUFFER

Integrated Device Technology 

ICS853111-01

LOW SKEW, 1-TO-9

DIFFERENTIAL-TO-3.3V LVPECL/ECL FANOUT BUFFER

APPLICATION INFORMATION

WIRING THE DIFFERENTIAL INPUT TO ACCEPT SINGLE ENDED LEVELS

Figure 1 shows an example of the differential input that can

be wired to accept single ended levels. The reference voltage

level VBB generated from the device is connected to the

negative input. The C1 capacitor should be located as close

as possible to the input pin.

VCC

C1

0.1u

CLK_IN

PCLK

VBB

nPCLK

FIGURE 1. SINGLE ENDED LVPECL SIGNAL DRIVING DIFFERENTIAL INPUT

TERMINATION FOR LVPECL OUTPUTS

The clock layout topology shown below is a typical termina-

tion for LVPECL outputs. The two different layouts mentioned

are recommended only as guidelines.

FOUT and nFOUT are low impedance follower outputs that gen-

erate ECL/LVPECL compatible outputs.Therefore, terminating

resistors (DC current path to ground) or current sources must

be used for functionality. These outputs are designed to drive

50Ω transmission lines. Matched impedance techniques should

be used to maximize operating frequency and minimize signal

distortion. Figures 2A and 2B show two different layouts which

are recommended only as guidelines. Other suitable clock lay-

outs may exist and it would be recommended that the board

designers simulate to guarantee compatibility across all printed

circuit and clock component process variations.

Zo = 50Ω

FOUT

FIN

Zo = 50Ω

50Ω

RTT =

1

((VOH + VOL) / (VCC – 2)) – 2

Zo

50Ω

VCC - 2V

RTT

FOUT

3.3V

125Ω

125Ω

Zo = 50Ω

FIN

Zo = 50Ω

84Ω

84Ω

FIGURE 2A. LVPECL OUTPUT TERMINATION

853111AV-01

FIGURE 2B. LVPECL OUTPUT TERMINATION

7

REV. A NOVEMBER 14, 2007

Share Link: