17448 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

일치하는 목록

17448

BGA & CSP Rework System

Unspecified 

Camera Features (not shown)

• YC Out (SVHS Video) Output Connector- When using a high resolution monitor, connect one end of the

SVHS cable into this receptacle and the other end to the “SVHS In” receptacle located in the

rear of the monitor.

• Power Supply Connector - Insert the 12V connector extending from the rear of the BGA/CSP-3500

Main Unit into this receptacle.

• Video Out Connector - If using a monitor without SVHS capability, connect one end of the video cable

to this female BNC receptacle and the other to the monitor’s “Video In” connector

IV. SET-UP PROCEDURES

Prior to performing initial set-up, unpack all accessories from shipping containers. Check that your

BGA/CSP-3500 has arrived complete by verifying all of the accessories listed in Section II have been

included. After all components are located, begin setup.

Placement Section

IMPORTANT: There is a transportation screw located on the bottom of the placement arm and on the tool-

ing plate/component slide to stop these parts from moving during transportation. Completely loosen or

remove these screws prior to operation to allow these parts to move freely without any restrictions.

When setting up this equipment, be sure to arrange it in a position that allows the user to operate this

machine in a comfortable, well-spaced environment.

1. Remove the BGA/CSP-3500 Main Unit, Control Unit, Camera, 20” High-Resolution Monitor (optional)

and all accessories from there shipping containers.

2. Mount the camera to the lens by rotating the camera clockwise so that it fully screws onto the top of

the lens assembly.

3. Connect the black cable extending from the rear of the BGA/CSP-3500 base unit to the connector

marked “12VDC IN” located on the rear of the camera.

4. Connect one end of the appropriate video cable (SVHS or BNC) to the appropriate video output

connector (“Y/C Out” for SVHS or “Video Out” for standard video) on the rear of the camera. Connect

the other end to the correct input on the rear of the monitor.

5. Connect the 5 pin female connector extending from the FS-24 footswitch to the corresponding 5 pin

male connector located on the rear of the BGA/CSP-3500 Main Unit.

6. Select the medium vacuum pipette and attach it to the vacuum shaft of the Placement Head.

IMPORTANT: Every BGA/CSP-3500 Rework System has been factory calibrated.

Recalibration may be required after initial setup due to shipping or rough handling. Verifying calibration is

strongly recommended prior to initial use. This procedure is thoroughly discussed later in the manual in the

section titled “Calibration Proceedure.”

Reflow Section

IMPORTANT: Prior to initial setup of your BGA/CSP-3500, please remove the transportation screw located on

the bottom of the BGA-3500 Series Control Unit. Tilt the unit on its side and remove the screw with a

Phillips-head screwdriver.

10

BGA-3500 Series Manual 5/01

Share Link: