DSS1NB3 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

일치하는 목록

DSS1NB3

EMIFIL® (Three-terminal capacitor)

Unspecified 

Spec No. JENF243F-0031-01

Reference Only P9/9

14.2 Cleaning

Products shall be cleaned on following conditions.

(1) Cleaning Temperature: 60℃ max.(40℃ max. for Isopropyl alcohol).

(2) Ultrasonic cleaning shall comply with the following conditions, avoiding the resonance phenomenon at the

mounted products and P.C.B.

Power：20W / l max.

Frequency：28kHz 40kHz

Time ：5 minutes max.

(3) Cleaning agent

1. alcohol cleaning agents.

・Isopropyl alcohol (IPA)

2. Aqueous cleaning agent

・Pine Alpha ST-100S

(4) Ensure that residual flux and residual cleaning agent is completely removed.

Products should be thoroughly dried after aqueous agent has been removed with de-ionized water.

(5) For other cleaning methods, please contact Murata engineering.

14.3 Operating Environment

(1) Do not use products in corrosive gases such as chlorine gas, acid or sulfide gas.

(2) Do not use products in the environment where water, oil or organic solvents may adhere to products.

(3) Do not adhere any resin to products, coat nor mold products with any resin (including adhesive)to prevent

mechanical and chemical stress on products.

14.4 Storage and handling requirements.

(1) Storage period

Use the products within 12 months after delivered.

Solderability should be checked if this period is exceeded.

(2) Storage environment condition

To prevent products quality deterioration, stored conditions should be controlled as follows ;

1. Temperature : -10 to 40 degrees centigrade

2. Humidity : 15 to 85% relative humidity

3. Products should be stored without sudden changes in temperature and humidity.

Don't keep products in corrosive gases such as sulfur,chlorine gas or acid,

or it may cause oxidization of lead terminals resulting in poor solderability.

4. Products should be stored on the palette for the prevention of the influence from humidity, dust and so

on.

5. Products should be stored in the warehouse without heat shock, vibration,direct sunlight and so on.

(3) Handling Conditions

Care should be taken when transporting or handling product to avoid excessive vibration or

mechanical shock.

△ 15. ! Note

(1)Please make sure that your product has been evaluated in view of your specifications with our product being

mounted to your product.

(2)You are requested not to use our product deviating from the reference specifications.

(3)The contents of this reference specification are subject to change without advance notice. Please approve our

product specifications or transact the approval sheet for product specifications before ordering.

MURATA MFG.CO., LTD

Share Link: