LH543620 데이터 시트보기 (PDF) - Sharp Electronics

부품명

상세내역

일치하는 목록

LH543620

1024 × 36 Synchronous FIFO

Sharp Electronics 

LH543620

1024 × 36 Synchronous FIFO

PIN NAME

DESCRIPTION

ASYNCHRONOUS CONTROL

RS

Master Reset. When asserted LOW, the LH543620 internal resource registers are set to their

default value. See Table 1. The status flags indicate Empty FIFO.

Output Enable. When asserted LOW, OE forces Q[35:0] to be active. When deasserted HIGH, OE

OE

forces Q[35:0] into a Hi-Z state. Bit 6 of the control register governs whether OE suppresses the

advancement of the Read Pointer (RP). In this case, OE must obey setup time and hold time

relative to CKO.

BYE

CAPR

Data-Bypass Enable. When asserted LOW, BYE connects Q[35:0] directly to D[35:0].

Command-Address Port Reference. CAPR determines the source of the 16-bit word to be loaded

into the resource register. Whenever CAPR is LOW, the word comes from the Input Port. Whenever

CAPR is HIGH (OE is HIGH), the word comes from the Output Port.

NOTES:

1. The destination of the resource register is always the Output Port.

2. CAPR is assumed to be a steady signal. It is not allowed to change ‘on-the-fly’ during operation.

CONTROL SIGNALS SYNCHRONOUS TO THE INPUT CLOCK

ENI1, ENI2

Input-Port Enables. ENI1 and ENI2 are active HIGH and synchronous to the rising edge of CKI.

Data is written into the FIFO memory array when both ENI1 and ENI2 are asserted HIGH.

NOTE: ENI1, ENI2 DO NOT ENABLE writing data into the Resource Registers or the Mailbox.

ADI[2:0]

Input-Port Address. ADI[2:0] specifies the Input-Port destination. See Table 1. ADI[2:0] is

synchronized to the rising edge of CKI.

WSI[1:0]

Input-Port Word-Width Selection. WSI[1:0] selects the Input-Port Word-Width. See Table 2.

WSI[1:0] is synchronous to the rising edge of CKI.

Table 1. Input-Port Address

ADI2 ADI1 ADI0

SELECTION

DEFAULT VALUE

(of the selected

REGISTER)

L L L RBASE register

0

L

L

H

ROFFSET

register

0

L H L AF offset value

8

L H H Parity register

0

H L L AE offset value

8

H L H Control register

1

H H L Mailbox

0

Resource

H H H registers write

disabled

Table 2. Input-Port Word-Width Selection

WSI1 WSI0

FUNCTION

L

L

9-Bit Data-Path

Width

Input data D[8:0]

L

H

18-Bit Data-Path

Width

Input data D[17:0]

H L Reserved

H

H

36-Bit Data-Path

Width

Input data D[35:0]

10

Share Link: