MIKROE-1200 데이터 시트보기 (PDF) - Unspecified
부품명
상세내역
일치하는 목록
MIKROE-1200 Datasheet PDF : 2 Pages
| |||
5. EEPROM Click™ Board Schematic
VCC
R1
2K2
VCC
J2
POWER J3
LD1
A0
A1
A2
J4
VCC
C1
U1
1
2
3
4
A0
A1
A2
VSS
24C08
100nF
R2
4K7
VCC
WP
SCL
SDA
8
7
6
5
R4
100K
R3
4K7
WP
SCL
SDA
VCC
PWR SEL
J1
AN
PWM
WP
RST
INT
CS
TX
SCK
RX
MISO
SCL
MOSI
SDA
SCL
SDA
+3.3V
+5V
GND
GND
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specification and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
6. SMD Jumpers
With J2, J3 and J4 SMD jumpers you can assign
the unique 3-bit chip enable address (A0, A1,
A2) to each DIP EEPROM memory. There is a
limited number of EEPROMs you can connect
to the same I2C bus depending on the memory
capacity (eg. 1x16Kbit, 2x8Kbit, 4x4Kbit,
8x2Kbit or 8x1Kbit). SMD jumper J1 is used
to select 5V or 3.3V power supply (default
position is 3.3V).
7. Code Examples
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
.com
8. Support
MikroElektronika offers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
Share Link: 