7641 데이터 시트보기 (PDF) - Mitsumi

부품명

상세내역

일치하는 목록

7641

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

Mitsumi 

PRELIMINARY NSocothimcaene:gpTeah.riasmisetnrioct laimfiintsalasrepescuibfijceacttioton.

MITSUBISHI MICROCOMPUTERS

7641 Group

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

qStatus Register (SRD)

The status register indicates operating status of the flash memory

and status such as whether an erase operation or a program

ended successfully or in error. It can be read by writing the read

status register command (7016). Also, the status register is

cleared by writing the clear status register command (5016).

Table 34 lists the definition of each status register bit. After releas-

ing the reset, the status register becomes “8016”.

Table 34 Status register (SRD)

SRD0 bits

SR7 (bit7)

SR6 (bit6)

SR5 (bit5)

SR4 (bit4)

SR3 (bit3)

SR2 (bit2)

SR1 (bit1)

SR0 (bit0)

Status name

Sequencer status

Reserved

Erase status

Program status

Reserved

Reserved

Reserved

Reserved

•Sequencer status (SR7)

The sequencer status indicates the operating status of the the

flash memory.

After power-on and recover from deep power down mode, the se-

quencer status is set to “1” (ready).

This status bit is set to “0” (busy) during write or erase operation

and is set to “1” upon completion of these operations.

•Erase status (SR5)

The erase status indicates the operating status of erase operation.

If an erase error occurs, it is set to “1”. When the erase status is

cleared, it is set to “0”.

•Program status (SR4)

The program status indicates the operating status of write opera-

tion. If a write error occurs, it is set to “1”. When the program

status is cleared, it is set to “0”.

Definition

“1”

“0”

Ready

Busy

-

-

Terminated in error

Terminated normally

Terminated in error

Terminated normally

-

-

-

-

-

-

-

-

133

Share Link: