HB288096A6 데이터 시트보기 (PDF) - Hitachi -> Renesas Electronics

부품명

상세내역

일치하는 목록

HB288096A6

FLASH ATA Card 1 GByte/800 MByte/640 MByte/448 MByte/320 MByte 256 MByte/192 MByte/160 MByte/128 MByte 96 MByte/64 MByte/32 MByte

Hitachi -> Renesas Electronics 

HB2881000/800/640/448/320/256/192/160/128/096/064/032A6

Signal name

Direction Pin No.

Description

-CSEL

I

56

(PC Card Memory mode)

This signal is not used.

-CSEL

(PC Card I/O mode)

-CSEL

(True IDE mode)

This signal is used to configure this device as a

Master or a Slave when configured in the True IDE

mode. When this pin is grounded, this device is

configured as a Master. When the pin is open, this

device is configured as a Slave.

D15 to D0

I/O

(PC Card Memory mode)

41, 40, 39, 38, Data bus is D15 to D0. D0 is the LSB of the even byte

37, 66, 65, 64, 6, of the word. D8 is the LSB of the odd byte of the

5, 4, 3, 2, 32, 31, word.

30

D15 to D0

(PC Card I/O mode)

D15 to D0

(True IDE mode)

GND

—

(PC Card Memory mode)

1, 34, 35, 68

Ground

GND

(PC Card I/O mode)

GND

(True IDE mode)

-INPACK

O

60

(PC Card Memory mode)

This signal is not used and should not be connected

at the host.

-INPACK

(PC Card I/O mode)

Input Acknowledge

This signal is asserted low by this card when the card

is selected and responding to an I/O read cycle at the

address that is on the address bus during -CE and

-IORD are low. This signal is used for the input data

buffer control.

-INPACK

(True IDE mode)

This signal is not used and should not be connected

at the host.

-IORD

I

44

(PC Card Memory mode)

This signal is not used.

-IORD

(PC Card I/O mode)

-IORD is used for control of read data in I/O task file

area. This card does not respond to -IORD until I/O

card interface setting up.

-IORD

(True IDE mode)

-IORD is used for control of read data in I/O task file

area. This card does not respond to -IORD until True

IDE interface setting up.

6

Share Link: