1874I 데이터 시트보기 (PDF) - STMicroelectronics
부품명
상세내역
일치하는 목록
1874I Datasheet PDF : 26 Pages
| |||
TS1871-TS1872-TS1874
Absolute maximum ratings and operating conditions
1
Absolute maximum ratings and operating conditions
Table 1. Absolute maximum ratings
Symbol
Parameter
Value
Unit
VCC
Vid
Vin
Tstg
Tj
Rthja
Supply voltage(1)
Differential input voltage(2)
Input voltage
Storage temperature
Maximum junction temperature
Thermal resistance junction to ambient (3)
SOT23-5
DIP8
DIP14
MiniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
7
±1
VDD -0.3 to VCC +0.3
-65 to +150
150
250
85
66
190
125
103
120
100
V
V
V
°C
°C
°C/W
Thermal resistance junction to case
Rthjc
SOT23-5
DIP8
DIP14
MiniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
81
41
33
39
°C/W
40
31
37
32
ESD
HBM: human body model(4)
MM: machine model(5)
CDM: charged device model(6)
2
kV
200
V
1.5
kV
Latch-up immunity
200
mA
Lead temperature (soldering, 10 sec)
Output short-circuit duration
250
°C
see note(7)
1. All voltage values, except differential voltage are with respect to network terminal.
2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. If Vid > ±1V, the
maximum input current must not exceed ±1mA. When Vid > ±1V, add an input series resistor to limit input current.
3. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuits on all
amplifiers.
4. Human body model: A 100pF capacitor is charged to the specified voltage, then discharged through a 1.5kΩ resistor
between two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.
5. Machine model: A 200pF capacitor is charged to the specified voltage, then discharged directly between two pins of the
device with no external series resistor (internal resistor < 5Ω). This is done for all couples of connected pin combinations
while the other pins are floating.
6. Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly
to the ground through only one pin. This is done for all pins.
7. Short-circuits from the output to VCC can cause excessive heating. The maximum output current is approximately 80mA,
independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
3/26
Share Link: 