TLE4253E 데이터 시트보기 (PDF) - Infineon Technologies
부품명
상세내역
일치하는 목록
TLE4253E Datasheet PDF : 22 Pages
| |||
3
Pin Configuration
3.1
Pin Assignment
TLE4253
Pin Configuration
Q
GND
GND
FB
1
8
2
7
3
6
4 TLE4253GS 5
I
GND
GND
EN/ADJ
Q
n. c.
n. c.
FB
1
8
2
7
3
6
4
5
TLE4253 E
I
n. c.
GND
EN/ADJ
Figure 2 Pin Configuration and Block Diagram
3.2
Pin Definitions and Functions
Pin
Symbol
1
Q
2, 3, 6, 7 GND
6
GND
2, 3, 7 n. c.
4
FB
5
EN/ADJ
8
I
–
EP
Function
Tracker Output.
Block to GND with a capacitor close to the IC terminals, respecting capacitance and ESR
requirements given in the table “Functional Range”.
Ground reference (version TLE4253GS only).
Interconnect the pins on PCB. Connect to heatsink area.
Ground (version TLE4253E only).
Connect to exposed pad.
Not connected (version TLE4253E only).
Connect to GND externally.
Feedback input for tracker.
Non inverting input of the internal error amplifier to control the output voltage.
Connect this pin directly to the output pin in order to obtain lower or equal output voltages
with respect to the reference voltage and connect a voltage divider for higher output
voltages than the reference (see application information).
Adjust / Enable.
Connect the reference to this pin. The active high signal of the reference turns on the
device, with active low the tracker is disabled. The reference voltage can be connected
directly or by a voltage divider for lower output voltages (see application information).
Input.
IC supply. For compensating line influences, a capacitor close to the IC terminals is
recommended.
Exposed pad (version TLE4253E only).
Attach the exposed pad on package bottom to the heatsink area on circuit board.
Connect to GND.
Data Sheet
4
Rev. 1.2, 2009-11-09
Share Link: 