STV8162(2009) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

일치하는 목록

STV8162
(Rev.:2009)

+5 V, +5 V and +8 V triple voltage regulator with disable and reset functions

STMicroelectronics 

Circuit description

3

Circuit description

STV8162

The STV8162 and STV8162D are triple-voltage regulators with reset and disable functions.

The three regulation parts are supplied from a single voltage reference circuit trimmed by

zener zapping during EWS testing. Since the supply voltage of this voltage reference is

connected to pin INPUT1 (VIN1), the second and third regulators will not work if pin INPUT1

is not supplied.

The output stages are designed using a Darlington configuration with a typical dropout

voltage of 1.0 V.

In all applications, all three inputs must be polarized. If outputs 2 or 3 are not used, the

corresponding inputs must be connected to Input 1.

The disable circuit will switch off pins OUTPUT2 and OUTPUT3 if a voltage less than 0.8 V

is applied to pin DISABLE.

The reset circuit checks the voltage at pin OUTPUT1. If this voltage drops below

VOUT1-0.25 V (4.75 V Typ.), the "a" comparator (Figure 4) rapidly discharges the external

) capacitor (Ce) and the reset output immediately switches to low. When the voltage at pin

t(s OUTPUT1 exceeds VOUT1-0.175 V (4.825 V Typ.), the VCe voltage increases linearly to the

c reference voltage (VREF = 2.5 V) corresponding to a reset pulse delay (tRD)as shown in

u Figure 5.

rod tRD

=

C-----e----×------2---.--5----V--

10μA

te P Afterwards, the reset output returns to high. To avoid glitches in the reset output, the second

Obsolete Product(s) - Obsole comparator "b" has a large hysteresis (1.9 V).

6/14

Share Link: