SST34HF1641J 데이터 시트보기 (PDF) - Silicon Storage Technology
부품명
상세내역
일치하는 목록
SST34HF1641J Datasheet PDF : 37 Pages
| |||
16 Mbit Concurrent SuperFlash + 4/8 Mbit PSRAM ComboMemory
SST34HF1641J / SST34HF1681J
Data Sheet
indicate the completion of Program operation. To protect
against inadvertent flash write, the SST34HF16x1J
devices contain on-chip hardware and software data pro-
tection schemes.
The flash and PSRAM operate as two independent mem-
ory banks with respective bank enable signals. The mem-
ory bank selection is done by two bank enable signals. The
PSRAM bank enable signals, BES1# and BES2, select the
PSRAM bank. The flash memory bank enable signal,
BEF#, has to be used with Software Data Protection (SDP)
command sequence when controlling the Erase and Pro-
gram operations in the flash memory bank. The memory
banks are superimposed in the same memory address
space where they share common address lines, data lines,
WE# and OE# which minimize power consumption and
area.
Designed, manufactured, and tested for applications requir-
ing low power and small form factor, the SST34HF16x1J
are offered in extended temperatures and a small footprint
package to meet board space constraint requirements. See
Figures 4 and 5 for pin assignments.
Device Operation
The SST34HF16x1J uses BES1#, BES2 and BEF# to
control operation of either the flash or the PSRAM memory
bank. When BEF# is low, the flash bank is activated for
Read, Program or Erase operation. When BES1# is low,
and BES2 is high the PSRAM is activated for Read and
Write operation. BEF# and BES1# cannot be at low level,
and BES2 cannot be at high level at the same time. If all
bank enable signals are asserted, bus contention will
result and the device may suffer permanent damage.
All address, data, and control lines are shared by flash and
PSRAM memory banks which minimizes power consump-
tion and loading. The device goes into standby when BEF#
and BES1# bank enables are raised to VIHC (Logic High) or
when BEF# is high and BES2 is low.
Concurrent Read/Write Operation
Dual bank architecture of SST34HF16x1J devices allows
the Concurrent Read/Write operation whereby the user
can read from one bank while programming or erasing in
the other bank. This operation can be used when the user
needs to read system code in one bank while updating
data in the other bank. See Figures 2 and 3 for dual-bank
memory organization.
Concurrent Read/Write States
Flash
Bank 1
Read
Write
Write
No Operation
Write
No Operation
Bank 2
Write
Read
No Operation
Write
No Operation
Write
PSRAM
No Operation
No Operation
Read
Read
Write
Write
Note: For the purposes of this table, Write means to perform
Block-/Sector-Erase or Program operations
as applicable to the appropriate bank.
Flash Read Operation
The Read operation of the SST34HF16x1J is controlled by
BEF# and OE#, both have to be low for the system to
obtain data from the outputs. BEF# is used for device
selection. When BEF# is high, the chip is deselected and
only standby power is consumed. OE# is the output control
and is used to gate data from the output pins. The data bus
is in high impedance state when either BEF# or OE# is
high. Refer to the Read cycle timing diagram for further
details (Figure 9).
©2006 Silicon Storage Technology, Inc.
2
S71336-00-000
8/06
Share Link: 