SAB-80C517A-N18 데이터 시트보기 (PDF) - Siemens AG
부품명
상세내역
일치하는 목록
SAB-80C517A-N18 Datasheet PDF : 77 Pages
| |||
SAB 80C517A/83C517A-5
Accesses to XRAM
Because the XRAM is used in the same way as external data memory the same instruction
types must be used for accessing the XRAM.
Note: If a reset occurs during a write operation to XRAM, the effect on XRAM depends on the
cycle which the reset is detected at (MOVX is a 2-cycle instruction):
Reset detection at cycle 1: The new value will not be written to XRAM. The old value
is not affected.
Reset detection at cycle 2: The old value in XRAM is overwritten by the new value.
Accesses to XRAM using the DPTR
There are a Read and a Write instruction from and to XRAM which use one of the 16-bit DPTR
for indirect addressing. The instructions are:
MOVX A, @DPTR (Read)
MOVX
@DPTR, A (Write)
Normally the use of these instructions would use a physically external memory. However, in the
SAB 80C517A the XRAM is accessed if it is enabled and if the DPTR points to the XRAM
address space (DPTR F800H).
Accesses to XRAM using the Registers R0/R1
The 8051 architecture provides also instructions for accesses to external data memory range
which use only an 8-bit address (indirect addressing with registers R0 or R1). The instructions
are:
MOVX A, @Ri (Read)
MOVX
@Ri, A (Write)
In application systems, either a real 8-bit bus (with 8-bit address) is used or Port 2 serves as
page register which selects pages of 256-byte. However, the distinction, whether Port 2 is
used as general purpose I/O or as "page address" is made by the external system design. From
the device’s point of view it cannot be decided whether the Port 2 data is used externally as
address or as I/O data!
Hence, a special page register is implemented into the SAB 80C517A to provide the possibility
of accessing the XRAM also with the MOVX @Ri instructions, i.e. XPAGE serves the same
function for the XRAM as Port 2 for external data memory.
Semiconductor Group
20
1994-05-01
Share Link: 