RT9275 데이터 시트보기 (PDF) - Richtek Technology
부품명
상세내역
일치하는 목록
RT9275 Datasheet PDF : 14 Pages
| |||
Preliminary
RT9275
Application Information
Output Voltage Setting
Referring to Typical Application Circuits, the output voltage
of the switching regulator (VOUT) can be set with Equation
(1).
R1
VOUT = ( 1+ ) ×1.25V
(1)
R2
Feedback Loop Design
Referring to Typical Application Circuits. The selection of
R1 and R2 based on the trade-off between quiescent current
consumption and interference immunity is stated below:
z Follow Equation (1)
z Higher R reduces the quiescent current (Path current =
1.25V/R2), however resistors beyond 5MΩ are not
recommended.
z Lower R gives better noise immunity, and is less sensitive
to interference, layout parasitics, FB node leakage, and
improper probing to FB pins.
VOUT
Layout Guide
z A full GND plane without gap break.
z VDD to GND noise bypass − Short and wide connection
for the 1μF MLCC capacitor between Pin5 and Pin3.
z VIN to GND noise bypass − Add a capacitor close to L1
inductor, when VIN is not an idea voltage source.
z Minimized FB node copper area and keep far away from
noise sources.
z Minimized parasitic capacitance connecting to LX and
EXT nodes, which may cause additional switching loss.
Board Layout Example (2-Layer Board)
(Refer to Typical Application Circuit for the board)
Prober Parasitics
_
Q
+
R1
FB Pin
R2
z A proper value of feed forward capacitor parallel with R1
can improve the noise immunity of the feedback loops,
especially in an improper layout. An empirical suggestion
is
1 = 10 to 20kHz
2πR1C4
For applications without standby or suspend modes, lower
values of R1 and R2 are preferred. For applications
concerning the current consumption in standby or suspend
modes, the higher values of R1 and R2 are needed. Such
“high impedance feedback loops” are sensitive to any
interference, which require careful layout and avoid any
interference, e.g. probing to FB pin.
- Top Layer -
DS9275-06 March 2007
- Bottom Layer -
www.richtek.com
13
Share Link: 