LC866528A 데이터 시트보기 (PDF) - SANYO -> Panasonic

부품명

상세내역

일치하는 목록

LC866528A

8-Bit Single Chip Microcontroller

SANYO -> Panasonic 

LC866548/40/32/28/24A

(14) Multiplication and division

- 16 bit × 8 bit (7 instruction cycle times)

- 16 bit ÷ 8 bit (7 instruction cycle times)

(15) Three oscillation circuits

- On-chip RC oscillation circuit used for the system clock

- On-chip CF oscillation circuit used for the system clock

- On-chip Crystal oscillation circuit used for the system clock and for time-base clock

Note : External resisters (Rf, Rd) are required

(16) Standby function

- HALT mode function

The HALT mode is used to reduce the power dissipation. In this operation mode, the program execution is stopped.

This operation mode can be released by the interrupt request signals or the initial system reset request signal.

- HOLD mode function

The HOLD mode is used to stop all the oscillations ;

RC (internal), CF and Crystal oscillations. This mode can be released by the following operations.

• Reset terminal ( RES ) set to low level.

• Input a assigned level to P70/INT0/T0IN or P71/INT1/T0IN terminal.

• Input a Port0 interrupt condition.

(17) Factory shipment

QFP100E delivery form

(18) Development Tools

- Evaluation chip

- EPROM version

- One time version

- Emulator

: LC866094

: LC86E6548

: LC86P6548

: EVA86000 + ECB866500 (Evaluation chip board) + POD866500 (Pod)

• Notes for use

Follow the under table.

Frequency range of the system clock

15kHz to 3MHz

30kHz to 6MHz

Internal RC oscillation

Voltage range

4.5V to 6.0V

Clock Divider

1/1

1/1, 1/2

1/1, 1/2

Note

Can not use 1/2 divider

No.6700-4/21

Share Link: