PI3B3257 데이터 시트보기 (PDF) - Pericom Semiconductor
부품명
상세내역
일치하는 목록
PI3B3257 Datasheet PDF : 5 Pages
| |||
PI3B3257
3.3V, Quad 2:1
Mux/DeMux NanoSwitch™
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ..................................................................... –65°C to +150°C
Ambient Temperature with Power Applied .................................... –40°C to +85°C
Supply Voltage to Ground Potential.................................................–0.5V to +4.6V
DC Input Voltage .............................................................................–0.5V to +4.6V
DC Output Current........................................................................................ 120mA
Power Dissipation ............................................................................................ 0.5W
Note:
Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only
and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not
mplied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.3V ±10%)
Parameters
Description
Test Conditions(1)
Min. Typ.(2) Max. Units
VIH
VIL
IIH
IIL
IOZH
VIK
RON
Input HIGH Voltage
Input LOW Voltage
Input HIGH Current
Input LOW Current
High Impedance Output Current
Clamp Diode Voltage
Switch On-Resistance(3)
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
VCC = Max., VIN = VCC
VCC = Max., VIN = GND
0 ≤ In, Yn ≤ VCC
VCC = Min., IIN = –18mA
VCC = Min., VIN = 0.0V,
Ion = 48mA or 64mA
VCC = Min., VIN = 2.4V, ION = 15mA
2
V
–0.5
0.8
±1
±1 µA
±1
–1.2 V
5
8
Ω
8
17
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (I,Y) pins.
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(1)
Description
Test Conditions
CIN
Input Capacitance
COFFYN
COFFIN
YN Capacitance, Switch OFF
IN Capacitance, Switch OFF
VIN = 0V
CON
IN/YN Capacitance, Switch ON
Notes:
1. This parameter is determined by device characterization but is not production tested.
Typ.
Units
3.0
17.0
pF
8.5
25
06-0220
2
PS8151K
05/16/06
Share Link: 