PCA9545A 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

일치하는 목록

PCA9545A

4-channel I2C switch with interrupt logic and reset

Philips Electronics 

Philips Semiconductors

PCA9545A

4-channel I2C switch with interrupt logic and reset

8. Characteristics of the I2C-bus

The I2C-bus is for 2-way, 2-line communication between different ICs or modules. The two

lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be

connected to a positive supply via a pull-up resistor when connected to the output stages

of a device. Data transfer may be initiated only when the bus is not busy.

8.1 Bit transfer

One data bit is transferred during each clock pulse. The data on the SDA line must remain

stable during the HIGH period of the clock pulse as changes in the data line at this time

will be interpreted as control signals (see Figure 8).

SDA

SCL

Fig 8. Bit transfer

data line

stable;

data valid

change

of data

allowed

mba607

8.2 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW

transition of the data line, while the clock is HIGH is defined as the START condition (S).

A LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the

STOP condition (P) (see Figure 9).

SDA

SCL

S

START condition

Fig 9. Definition of START and STOP conditions

SDA

P

STOP condition

SCL

mba608

9397 750 14311

Product data sheet

Rev. 03 — 3 March 2005

© Koninklijke Philips Electronics N.V. 2005. All rights reserved.

9 of 27

Share Link: