PCA5007H/000/F2 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

일치하는 목록

PCA5007H/000/F2

Pager baseband controller

Philips Electronics 

Philips Semiconductors

Pager baseband controller

Product specification

PCA5007

SYMBOL

P1.4

VSS

VDD

ALE

PSEN

EA

TCLK

VPP

P1.6(SCL)

P1.7(SDA)

XTL2

XTL1

VBAT

VDD(DC)

VIND

VSS(DC)

RESETIN

PIN TYPE

DESCRIPTION

29

I/O If the UART is disabled (ENS1 in S1CON.4 = 0) then P1.4 can be used as

general purpose P1 port pin. If the UART function is required, then a logic 1

must be written to P1.4. This I/O then becomes the TXD/clock line of the UART.

P1.4 has external interrupt INT6 (X6) assigned.

30

S ground (connected to substrate)

31

S supply voltage for the core logic and most peripheral drivers of the PCA5007

(see VDDA)

32

I/O Address Latch Enable: output pulse for latching the low byte of the address

during an access to external memory.

33

I/O Program Store Enable: the read strobe to external program memory. When

the device is executing code from the external program memory, PSEN is

activated for each code byte fetch.

34

I/O External Access Enable: EA must be externally held LOW to enable the

device to fetch code from external program memory locations 0000H to 4FFFH.

If EA is held HIGH, the device executes from internal program memory unless

the program counter contains an address greater the 4FFFH (20 kbytes).

35

I clock input for use as timing reference in external access mode and emulation

36

S Programming voltage (12.5 V) for the OTP. Is connected to VSS in the

application.

37

I/O If the I2C-bus is disabled (ENS1 in S1CON.6 = 0) then P1.6 can be used as

general purpose P1 port pin. If the I2C-bus function is required, then a logic 1

must be written to P1.6. This I/O then becomes the clock line of the I2C-bus.

P1.6 is equipped with an open-drain output buffer. The pin has no clamp diode

to VDD.

38

I/O If the I2C-bus is disabled (ENS1 in S1CON.6 = 0) then P1.7 can be used as

general purpose P1 port pin. If the I2C-bus function is required, then a logic 1

must be written to P1.7. This I/O then becomes the data line of the I2C-bus.

P1.7 is equipped with an open-drain output buffer. The pin has no clamp diode

to VDD.

39

O output from the current source oscillator amplifier

40

I input to the inverting oscillator amplifier and time reference for pager decoder,

real-time clock and timers

41

S Supply terminal from battery. Is used for supplying parts of the chip that need to

operate at all times.

42

O Supply voltage output of the DC/DC converter. An external capacitor is

required.

43

I Current input for the DC/DC converter. The booster inductor needs to be

connected externally.

44

S ground (connected to substrate) OTP

45

I Schmitt trigger reset input for the PCA5007. External R and C need to be

connected to the battery supply. All internal storage elements (except

microcontroller RAM) are initialized when this input is activated.

1998 Oct 07

7

Share Link: