PCA5007H 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

일치하는 목록

PCA5007H

Pager baseband controller

Philips Electronics 

Philips Semiconductors

Pager baseband controller

Product specification

PCA5007

6.4 Memory organization

The PCA5007 has a program memory (OTP) plus data

memory (RAM) on-chip. The device has separate address

spaces for program and data memory (see Fig.4). If ports

P0 and P2 are not used as I/O signals these pins can be

used to address up to 64 kbytes of external program

memory. In this case, the CPU generates the latch signal

(ALE) for an external address latch and the read strobe

(PSEN) for external program memory. External data

memory is not supported.

6.4.1 PROGRAM MEMORY

After reset the CPU begins execution of the program

memory at location 0000H. The program memory can be

implemented in either internal OTP or external memory.

If the EA pin is strapped to VDD, then program memory

fetches are directed to the internal program memory. If the

EA pin is strapped to VSS, then program memory fetches

are directed to external memory.

Programming the on-chip OTP is detailed in Chapter 15.

Usually Philips will deliver programmed parts to a

customer. Supply of blank engineering samples is

possible, but then Philips cannot give any guarantee on

the programmability and retention of the program memory.

6.4.2 DATA MEMORY

The PCA5007 contains 1024 bytes of internal RAM

(consisting of 256 bytes standard RAM and 768 bytes

AUX-RAM) and Special Function Registers (SFRs).

Figure 4 shows the internal data memory space divided

into the lower 128 bytes the upper 128 bytes and the SFR

space and 768 bytes auxiliary RAM. Internal RAM

locations 0 to 127 are directly and indirectly addressable.

Internal RAM locations 128 to 255 are only indirectly

addressable. The SFR locations 128 to 255 are only

directly addressable and the auxiliary RAM is indirectly

addressable as external RAM (MOVX). External Data

Memory (EDM) is not supported.

6.4.3 SPECIAL FUNCTION REGISTERS

The second 128 bytes are the address locations of the

special function registers. Table 1 shows the special

function registers space. The SFRs include the port

latches, timers, peripheral control, serial I/O registers, etc.

These registers can only be accessed by direct

addressing. There are 128 bit addressable locations in the

SFR address space (those SFRs whose addresses are

divisible by eight).

handbook, full pagewFidFthFFH

EXTERNAL

4FFFH

INTERNAL

(EAN = 1)

EXTERNAL

(EAN = 0)

0

PROGRAM MEMORY

2FFH

FFH

INDIRECT

DIRECT

ADDRESSING ADDRESSING

80H

7FH INDIRECT AND

DIRECT

ADDRESSING

00H

INDIRECT

ADDRESSING

WITH DPTR

INDIRECT

ADDRESSING

WITH Ri, DPTR

100H

0FFH

000H

Internal RAM SFR space

Internal XRAM

DATA MEMORY

External XRAM

is not supported

MGR110

Fig.4 Memory map.

1998 Oct 07

11

Share Link: