NCP374 데이터 시트보기 (PDF) - ON Semiconductor

부품명

상세내역

일치하는 목록

NCP374

Overvoltage Up to +30 V and Down to -30 V with Load Switch Function

ON Semiconductor 

Vbus

tON

IN

/FLAG

/DIR

/EN

Transciever

NCP374

Battery output

Transciever

Downstream Vbu s connection

Figure 5. FLAG Status in Vbus Mode

Logic Inputs

To enable Charge operation (Charge Mode), the DIR pin

shall be forced to low and EN to high. A high level on the

DIR pin disconnects IN pin from Vbus pin. DIR does not

overdrive an OVLO or UVLO fault (FLAG status is still

available).

Table 1. TABLE SELECTION OF CHARGE MODES

OVP @ VBUS (+28 V,

DIR

EN

MODE

−28 V, OVLO 5.77 V)

0

0

NA

NA

0

1

Charge

Yes

1

0

VBUS

Yes

1

1

Disable

Yes (out off)

Protection

OCP (IN to VBUS)

NA

NA

Yes

NA

OCP (VBUS to IN)

NA

NA

NA

NA

Negative Voltage and Reverse Current

The device protects the system connected on IN pin from

negative voltage occurring on Vbus pin, down to −28 V.

When a negative voltage occurs, the IN pins are

disconnected from Vbus pins . This negative protection is

available in all modes

Thermal Shutdown Protection

In case of internal overheating, the integrated thermal

shutdown protection allows to open the internal MOSFET

in order to instantaneously decrease the device temperature.

The thermal threshold has been set at 150°C. FLAG is then

tied to low to inform the MCU.

As the thermal hysteresis is 30°C, the MOSFET will be

closed as soon the device temperature falls down to 120°C.

If the fault event is still present, the temperature increase

one more time and engages the thermal shutdown one more

time until fault event disappeared.

http://onsemi.com

9

Share Link: