PI5C6800QE 데이터 시트보기 (PDF) - Pericom Semiconductor
부품명
상세내역
일치하는 목록
PI5C6800QE Datasheet PDF : 5 Pages
| |||
PI5C6800
10-Bit Bus Switch with
Precharged Outputs
Absolute Maximum Ratings Over Free-Air Temperature Range(1)
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature .....................................................–65°C to +150°C
Supply Voltage Range.........................................................–0.5V to +7V
DC Input Voltage(2).............................................................–0.5V to +7V
Input Clamp Current, IIK (V1<0) .................................................. –50mA
DC Output Current........................................................................ 120mA
Power Dissipation(3) ........................................................................ 0.5W
Notes:
1. Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and
functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
2. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
3. The maximum package power dissipation is calculated using a junction temperatue of 150°C and a board trace length of 750 mils.
Recommended Operating Conditions
Parameters
Description
Min.
Typ.
Units
VCC
Supply Voltage
4
5.5
BIASV
Supply Voltage
1.3
VCC
V
VIH
High-level input voltage
2
VIL
Low-level input voltage
0.8
TA
Operating free-air voltage
-40
85
°C
Electrical Characteristics (Over Recommended Operating Free-air Temperature Range)
Parameters
Test Condidtion
Min.
Typ.(3)
Max.
Units
VIK
VCC = 4.5V, II = -18mA
-1.2
V
II
VCC = 5.5V, VI = 5.5V or GND
±5
µA
IO
VCC = 4.5V, BIASV = 2.4V, VO = 0
-0.20
mA
ICC
∆ICC(2)
VCC = 5.5V, IO = 0, VI = VCC or GND
VCC = 3.6V, One input at 2.7V Other at VCC or GND
3
µA
2.5
mA
CIN
COFF
VI = 3V or 0
VO = 3V or 0, Switch Off
3.5
pF
4.5
VCC = 4V
VI = 2.4V, II = 15mA
14
22
RON(1)
VCC = 4.5V
VI = 0V, II = 64mA
VI = 0V, II = 30mA
5
7
Ω
5
7
VI = 2.4V, II = 15mA
10
15
Notes:
1. Measured by the voltage drop between the A and B terminals at the indicated current through the switch. On-State resistance is determined by
the lower of the voltages of the two (A or B) terminals.
2. This is the increase in supply current for control input.
3. All typical values are at VCC = 5V, TA = 25°C.
2
PS8194E
09/13/04
Share Link: 