MIC3975 데이터 시트보기 (PDF) - Micrel

부품명

상세내역

일치하는 목록

MIC3975

750mA µCap Low-Voltage Low-Dropout Regulator

Micrel 

MIC3975

TA(max) = maximum ambient operating temperature

For example, the maximum ambient temperature is 50°C,

the ΔT is determined as follows:

ΔT = 125°C – 50°C

ΔT = 75°C

Using Figure 4, the minimum amount of required copper can

be determined based on the required power dissipation. Power

dissipation in a linear regulator is calculated as follows:

PD = (VIN – VOUT) IOUT + VIN × IGND

If we use a 2.5V output device and a 3.3V input at an output

current of 750mA, then our power dissipation is as follows:

PD = (3.3V – 2.5V) × 750mA + 3.3V × 7.5mA

PD = 600mW + 25mW

PD = 625mW

From Figure 4, the minimum amount of copper required to

operate this application at a ΔT of 75°C is 160mm2.

Quick Method

Determine the power dissipation requirements for the design

along with the maximum ambient temperature at which the

device will be operated. Refer to Figure 5, which shows safe

Micrel

operating curves for three different ambient temperatures:

25°C, 50°C and 85°C. From these curves, the minimum

amount of copper can be determined by knowing the maxi-

mum power dissipation required. If the maximum ambient

temperature is 50°C and the power dissipation is as above,

625mW, the curve in Figure 5 shows that the required area

of copper is 160mm2.

The θJA of this package is ideally 80°C/W, but it will vary

depending upon the availability of copper ground plane to

which it is attached.

February 2005

11

MIC3975

Share Link: