MAX44281 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
일치하는 목록
MAX44281 Datasheet PDF : 10 Pages
| |||
MAX44281
Ultra-Small, Ultra-Thin, 4-Bump Op Amp
Absolute Maximum Ratings
VDD to GND..............................................................-0.3V to +6V
IN to GND.................................................................-0.3V to +6V
OUT to GND.................................(VGND - 0.3V) to (VDD + 0.3V)
Continuous Power Dissipation (TA = +70NC)
WLP (derate 9.7mW/NC above +70NC).........................303mW
Maximum Continuous Current into Any Pin....................P 20mA
Operating Temperature Range......................... -40NC to +125NC
Storage Temperature Range............................. -65NC to +150NC
Soldering Temperature (reflow).......................................+260NC
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation
of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
Package Thermal Characteristics (Note 1)
WLP
Junction-to-Ambient Thermal Resistance (θJA).........103°C/W
Note 1: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer
board. For detailed information on package thermal considerations, refer to www.maximintegrated.com/thermal-tutorial.
Electrical Characteristics
(VDD = 3.3V, VGND = 0V, RL = 10kΩ to VDD/2, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
DC PERFORMANCE (Note 1)
AV = 1V/V (MAX44281O)
0.1
Input Voltage Range (Note 3)
VIN
AV = 2V/V (MAX44281V)
0.05
AV = 10V/V (MAX44281U)
Gain Error
Input Offset Voltage (Note 2)
Input Offset Voltage Drift (Note 2)
Input Bias Current (Note 2)
Output Short-Circuit Current
Output Voltage Low
GE
VOS
VOS - TC
IB
ISC
VOL
AV = 1V/V (MAX44281O)
AV = 2V/V (MAX44281V)
AV = 10V/V (MAX44281U)
VIN = 150mV,
no load
AV = 1
AV = 2V/V
AV = 10V/V
TA = +25NC (Note 2)
TA = -40NC to +125NC
OUT to VDD or GND
ROUT = 10kI
ROUT = 600I
0.01
TYP MAX UNITS
0.01
0.2
0.3
20
20
20
2
1
50
VDD -
0.1
(VDD -
0.1)/2
(VDD -
0.1)/10
0.02
0.6
0.7
100
100
100
9
10
2000
0.02
0.1
V
%
FV
FV/NC
pA
mA
V
www.maximintegrated.com
Maxim Integrated │ 2
Share Link: 