M38504M6-XXXFP 데이터 시트보기 (PDF) - MITSUBISHI ELECTRIC

부품명

상세내역

일치하는 목록

M38504M6-XXXFP

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

MITSUBISHI ELECTRIC  

MITSUBISHI MICROCOMPUTERS

3850 Group (Spec. H)

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

PULSE WIDTH MODULATION (PWM)

The 3850 group (spec. H) has a PWM function with an 8-bit

resolution, based on a signal that is the clock input XIN or that

clock input divided by 2.

Data Setting

The PWM output pin also functions as port P44. Set the PWM

period by the PWM prescaler, and set the “H” term of output pulse

by the PWM register.

If the value in the PWM prescaler is n and the value in the PWM

register is m (where n = 0 to 255 and m = 0 to 255) :

PWM period = 255 ✕ (n+1) / f(XIN)

= 31.875 ✕ (n+1) µs

(when f(XIN) = 8 MHz,count source selection bit = “0”)

Output pulse “H” term = PWM period ✕ m / 255

= 0.125 ✕ (n+1) ✕ m µs

(when f(XIN) = 8 MHz,count source selection bit = “0”)

PWM Operation

When bit 0 (PWM enable bit) of the PWM control register is set to

“1”, operation starts by initializing the PWM output circuit, and

pulses are output starting at an “H”.

If the PWM register or PWM prescaler is updated during PWM

output, the pulses will change in the cycle after the one in which

the change was made.

31.875 ✕ m ✕ (n+1) µs

255

PWM output

T = [31.875 ✕ (n+1)] µs

m: Contents of PWM register

n : Contents of PWM prescaler

T : PWM period (when f(XIN) = 8 MHz,count source

selection bit = “0”)

Fig. 27 Timing of PWM period

Data bus

PWM

prescaler pre-latch

PWM

register pre-latch

Transfer control circuit

XIN

(XCIN at low-speed mode)

PWM

prescaler latch

Count source

selection bit

“0”

PWM prescaler

1/2 “1”

PWM

register latch

PWM register

Port P44

Port P44 latch

PWM enable bit

Fig. 28 Block diagram of PWM function

29

Share Link: